i just boughta bravada i believe the 4.3 to be out of something elsemy 97 has a knock sensor onthe driversside a big round 1 this has the plug in the same place but has about a 5/16 bolt that holds a little round black thing with plug that looks like a injector plug with two prongs unlike the one prong onthe big one.how could i get this to work? do you know what year motor this is.my other 4.3 has it in the head the big sensor wont fit there is there another place?
2007-05-12 15:02:27 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Chevrolet
Most 4.3L motors have the knock sensor located on the passenger side, into the lower block's coolant drain. It is right above and in front of the starter. I don't know what you are asking here??? You cannot tell the type of vehicle or year of the motor from where the knock sensor is located. You can move the sensor around as all you have to do is run more wire to it. Reword your question and be specific and clear.
2007-05-13 06:16:00 · answer #1 · answered by Deano 7 · 0⤊ 0⤋
First, be sure it is the correct knock sensor. There are some aftermarket ones out that are cheaper, but contains the wrong type of quartz and won't work. If all wiring is good and all sensors are covered (and 43 is knock sensor / circuit) then it is possible that the computer is faulty. Only other question is whether or not you have a basic engine noise that is intermittent. I had that happen in the past and seemed to confuse the computer. Hope this helps and good luck.
2016-05-17 04:08:57 · answer #2 · answered by concetta 4 · 0⤊ 0⤋
It's at the rear of the enginine on the left side
2007-05-13 12:58:27 · answer #3 · answered by kdiesel 3 · 0⤊ 0⤋
get somebody who can speak better english to help you . You dont make much sense here
2007-05-12 15:08:23 · answer #4 · answered by Maka 7 · 1⤊ 0⤋