English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

From my understanding you run the DSL into the wireless router with ethernet and then make sure your computers have the correct wireless cards in them. Is that correct?

2007-05-10 12:20:30 · 4 answers · asked by Brad 2 in Computers & Internet Computer Networking

4 answers

Wire from the wall goes to dsl modem/router(assuming that it's all one unit). Once the router is on, your computer will search for wireless networks and ask which one to connect to. Put in password of your network, then it should connect. Make sure your network is using encryption. Without it, all that you send on the internet is wide open.

2007-05-10 12:39:49 · answer #1 · answered by big mal 3 · 0 0

No. Here are the physical connections:

-Cable from the phone line wall socket to the DSL Modem.
-Ethernet cable from the DSL Modem to the router
-Ethernet cable from the routers ethernet port #1 to a computers ethernet port

After you do the initial setup of the router then you can disconnect the computer from the router if you want and either install a wireless adapter or turn on the built in wireless if you have that.

2007-05-10 12:31:38 · answer #2 · answered by Taba 7 · 0 0

think simple.
think of wireless as an invisible cable

but if i were a bettn person i would have to say you are havein problems connecting your wireless router to your dsl modem, you can connect wirelessly but cant get online and dont know why. the reason is your dsl is likeley useing nat and so is your router. you likely have a pppoe connection. so you need to access the configuration for your modem and put it in whats called bridged mode then access the configuratin of your wireless router and set i up as a PPPoE connection. put in your username and password and you should be able to connect wirelessly.

2007-05-10 12:39:07 · answer #3 · answered by Jware S 3 · 0 0

you would be wanting a prompt router to which your ethernet cord is going. Then at each and every pc you could the two placed a pci card or a usb dongle to allow them to connect this prompt community. be sure all of them artwork with the comparable protocol i.e. 802.eleven a,b or g. Then provide you router an IP and set this because of the fact the gateway for all different computers. the the remainder of the small print would be certainly attainable interior the documentation featuring the router. do no longer ignore to encrypt your community so as that undesirable people do no longer connect in.

2016-12-17 09:33:52 · answer #4 · answered by ? 4 · 0 0

fedest.com, questions and answers