2007-05-03 01:10:29 · 4 answers · asked by david n 1 in Consumer Electronics ➔ Other - Electronics
you may need the technician to come check that the gas has not all escaped - this does happen to my aircon sometimes, just a day or two after servicing
2007-05-03 01:14:11 · answer #1 · answered by PikC 5 · 0⤊ 0⤋
This is a trouble shooting issue. Does unit have a fused quick disconnect. Maybe blown fuse. Can be found in electrical box behind a/c. Is low-voltage wire going to condenser intact? Is circuit breaker or fuse to a/c circuit on or is it tripped? A/C contactor could be stuck.Is thermostat set to cool and is it set to the proper temperature so it will for ask a/c to turn on. Majority of the time it is not a refrigerant issue. However newer model a/c condensers do have a pressure switch that will shut off unit in order to protect compressor if there is a loss of refrigerant. Check the circuit breaker 1st. Check disconnect fuses. 2nd. Check condition of low voltage wire to condenser. Chech thermostat. You must check everything that will stop an a/c from running. Be careful. There is 220 volts going to a/c constantly. It takes 24 volts in the low voltage wire to complete the hi voltage circuit. If the unit is older, call a technician to check amp draw on compressor. But it does sound like there is a power issue . Hope this helps.
2007-05-05 11:17:58 · answer #2 · answered by nyboriqua911 2 · 0⤊ 0⤋
If it stopped cooling then it's most likely there's a leak and you've run low on the refrigerant.
If your air conditioner is using the newer refrigerant then you can buy a kit at your local heating/air place for a refill kit.
If it's the old R134 then you should get it serviced by a licensed technician.
2007-05-03 14:09:09 · answer #3 · answered by IKNOWALL 5 · 0⤊ 0⤋
have it serviced/looked at by a professional
2007-05-03 08:12:46 · answer #4 · answered by Bailey 5 · 0⤊ 0⤋