needs to be a metal primer
2007-04-25 03:31:52
·
answer #1
·
answered by Anonymous
·
1⤊
0⤋
The paint is not sticking to the metal. You should always prime metal before painting. If the pole is galvanized, you can wash it with an acid etch or vinegar to give the primer the best chance of holding. If you paint over the peeling paint, the problem will quickly reoccur. The most permanent solution would be to remove all the old paint and start over or simply repaint each year.
2007-04-21 11:57:29
·
answer #2
·
answered by ©2009 7
·
0⤊
0⤋
Sounds like you didn't sand and prime the metal. Raw metal needs to be primed with a metal primer before painting it or it will peel. Also, you could have painted the poles while they were wet. Clean your old paint off; sand and clean the poles, use a good metal primer, then paint it. That should do it..
2007-04-21 12:03:40
·
answer #3
·
answered by papaw 7
·
0⤊
0⤋
Epoxies are the suited, because of the fact they don't dry, they therapy. the two chemical components in epoxy are a coloring/coating and a hardening agent. The chemical reaction between the two contraptions up the epoxy like a sturdy action picture of plastic. So, unlike paint, it won't chip or peel aside. additionally, in case you prepare the floor of the concrete wisely, the epoxy seeps into the pores interior the concrete and makes an eternal bond that won't be able to be peeled up from the concrete. reckoning on the quantity of harm (like whether or not you're rolling heavy save equipment over the floor), an epoxy-lined concrete floor could desire to final an entire life.
2016-11-26 19:17:03
·
answer #4
·
answered by leister 4
·
0⤊
0⤋
Washing Line Poles
2016-10-07 07:32:23
·
answer #5
·
answered by Anonymous
·
0⤊
0⤋
scrape the chipping paint..then sand the poles lightly to give them tooth to hold paint...use a primer for metal....then a rust inhibitor paint for metal....go over all of this with polyurethane to protect the paint...you should be ok for 5 years or longer.
2007-04-21 11:58:19
·
answer #6
·
answered by debbie2243 7
·
0⤊
0⤋
rub them down with 120grade sandpaper if you rub throw to the metal no matter use a metal primer then an exterior undercoat & gloss. the cheapest why is to buy hammerite smooth finish metal paint
2007-04-21 12:00:53
·
answer #7
·
answered by PASTY 1
·
0⤊
0⤋
Did you use a metal primer ?
2007-04-21 11:59:54
·
answer #8
·
answered by LORD V 2
·
0⤊
0⤋