My subwoofer cuts out when the volume is set to low levels, but turns back on when volume is turned up?

Question

When the volume is at low levels, the sub will cut out. When the volume is turned up, the sub turns back on. Any ideas?

Could it be a poor ground? Or is the amp most likely shot?

Since the sub works at higher volumes, it is likely that the subwoofer is not the problem, correct?

Thanks

This has started happening recently as well. I've had no problems with this in the past.

Answer 1

it probabley isnt shuting off its just a sub is made for low sounds so then when u turn it down the low backround sounds dont come in as much as the other main sounds of the song

Answer 2

first element is to play with the area of the audio device and subwoofer, this can influence both time-honored frequency's responce and soundstaging. the numerous audio device might want to create a equivalent lateral triangle, with a decision of about 8ft from left and proper audio device and ideally some ft faraway from lower back walls. Subwoofer also needs to ideally be placed in the middle between the front audio device, and placed about a foot from the lower back wall. there's a huge false impression that bass isn't directional, it really is thoroughly pretend. in case you do not position the subwoofer in the middle you gained't get the most proper sound. nook loading is likewise no longer proper as this can truly provide you with the most volume of bass yet no longer the most proper bass element. the idea of placing the bypass-over (or extreme bypass) on your subwoofer is to get the subwoofer to supplement (or blend) with the numerous audio device roll off (it really is at 50hz) you'll favor the subwoofer to go back in round this frequency. To extreme a placing and also you'll get to a lot bass in the better bass area causing extra bass and shortage of element in different aspects of the music spectrum. To low a placing and also you'll have an total were there is bass options it really is lacking. A proper placing promises you sturdy bass element were you may hear all notes from each and each and every device in the bass section. Set volume to also get the right volume of bass so that you it does no longer mask something of the music. All speaker stages might want to be set on the listeners position ether with a VU meter, or by using ear so all audio device are on a similar volume. sturdy good fortune Kevin 40 years hi-end audio video professional

Answer 3

This is usually a symptom of a resistance in the signal path. Make sure your speaker wires are tightly secured at the box terminals and at the amp. Some boxes are equipped with "spring clip" speaker terminals, and these are notorious for breaking or wearing out so they won't hold the wire securely. You may also have a problem with an RCA cable or RCA input.

Answer 4

maybe your amp is having a problem with the low levels? did you fry something? not sure, but maybe take the amp out, open it up and check to see if you can find any burning or blackened parts.

Answer 5

what probably is happening is that you are not powering your subs enough at low vol. to make them move, therefore they are not creating sound.