i might have used to much baby shampoo in install solution.can i clean it up without having to apply a new sheet?maybe peel it back and use straight water? help !
2007-04-12 06:24:35 · 5 answers · asked by G-GAURD 1 in Home & Garden ➔ Do It Yourself (DIY)
There must be an obvious problem with your self installation; bubbles, streaks, Hazy milky look?
Bay shampoo is fine . Add a drop or two to a gallon of water. This should be fine. This is known as a slip solution. The key is to clean the window extremely well prior to the film install. Follow the manufacturer's instructions (if available. )
At this point I'd suggest that you pull off the film, re-clean and re-apply.
2007-04-13 11:18:18 · answer #1 · answered by Mike F 6 · 1⤊ 0⤋
I had mine professionally installed and they did not use baby shampoo, but dish washing solution was added to their spray bottle and only a couple of drops. Vinegar will cut through the baby shampoo, but if you are going to reapply the window film add a couple of drops of dish washing soap.
2007-04-12 06:29:57 · answer #2 · answered by eskie lover 7 · 0⤊ 0⤋
You will have to get the film off of the window and off of the film too, I would think.
Try water to get it off, and this time only one drop of dishwashing detergent. Don't need too much, as you have found out. Good luck
2007-04-12 06:34:37 · answer #3 · answered by Fordman 7 · 0⤊ 0⤋
Amonia will give it that effect.Did you use windex to clean it with
2007-04-12 12:31:34 · answer #4 · answered by Billy T 6 · 0⤊ 0⤋
DO WHAT YOU GOTTA DO
2007-04-12 06:30:06 · answer #5 · answered by kitty 6 · 0⤊ 1⤋