6v or 24v input to a 12v-220v transformer 1a 220va?

Question

say a 12v-220v transformer
input 12v and the output is 220v oviously

but if the input is 24v will the output be more than 220 v or
just 220v coz the primary is only 12v or 12 turns and can only take in 12v at a time.

or if the input is only 6 volts - will the output become less than 220v or the same 220v

Answer 1

The windings determine the ratio of change. If you hit it with less or more voltage, the output should be proportional.

Answer 2

The secondary could have 4 pickoff factors, equivalent to 0, 3, 6, and 12 volts. The turns ratio between accepted and complete secondary would be 220/12. The cord and center length for use will remember on the present score required. Or, you could bypass to Radio Shack (or a matching electronics save) and purchase one. I hung out in Saudi Arabia, the place the relatives means is 240 volt 3 area; many retailers are under pressure area to independent, so they're one hundred thirty five volts. I introduced digital equipment which replaced into meant for one hundred twenty volts, and that i offered a transformer with one hundred twenty volt accepted and 12 volt secondary, which I under pressure up in an autotransformer configuration to grant 122 volts, which replaced into close sufficient.

Answer 3

If the input is 24 volts, the output will be 440 volts, BUT don't do that because you'll likely burn up the transformer.

You CAN apply any voltage lower than the rated input and the output will be proportionately lower. If you apply 6 volts, you will get 110 volts out.

I hope this helps.