I have Tried putting it in valet mode. I open the switch to on position and press the valet switch for five seconds until the light comes on and then try to start the car and it wont start. Also tried disconnecting all the cables from the module and it wont do anything. Car is cranking all the lights on the dashboard comes on but it wont start. Please help
2007-03-28 11:55:13 · 3 answers · asked by Anonymous in Cars & Transportation ➔ Car Audio
In most cases the only vehicle-disabling feature that's used on a car alarm is a starter kill relay. If your car is cranking, that makes it unlikely that the alarm is causing the no-start condition unless some other kind of disable was installed; and even if a fuel-pump kill relay was used, unplugging the alarm module should have taken care of it.
2007-03-28 12:08:26 · answer #1 · answered by KaeZoo 7 · 0⤊ 0⤋
You did not say how long the alarm has been on the car. If it is a new addition, it may be the cause. However, the Prestige alarm is made by Audiovox and I know them to be very reliable. I suspect something else, after all it is a '96. After 11 years something is bound to go wrong. I would check the fuel pump relay. I had a '97 Taurus and that went out on mine twice during the 4 years I had it. I had the SVO V-6. Good luck - Gary
2007-03-28 12:03:04 · answer #2 · answered by g_dub54 2 · 0⤊ 0⤋
prestige alarm system are very good system i don't believe the alarm is the problem charge the battery overnight and try again if you want to disable the kill ignition find the orange cable comming out of the alarm and cut it
to put the alarm on valet mode you turn on the ginition flip or press the switch and turn off the ignition the red led will stay on
2007-03-28 14:29:31 · answer #3 · answered by conejote_99 7 · 0⤊ 0⤋