English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

My 2ga power wire just stopped delivering power and the only thing that it could be is the fuse, it dosen't look blown though because the metal inside isn't severed. its a little melted and contorted but not enought for me to think its blown...

2007-03-26 11:38:22 · 7 answers · asked by stillcole 2 in Cars & Transportation Car Audio

7 answers

Absolutely! If its brown or discolored and not blown, it's getting hot and is about to.
There is no reason other than a bad installation job that causes blown fuses. Period.
If the max current draw on your power wire is 200 amps, you'll need one slightly larger, like 225amps.

Again, THERE IS NO REASON OTHER THAN A BAD INSTALLATION JOB THAT CAUSES BLOWN FUSES.
Good Luck!

2007-03-27 18:57:42 · answer #1 · answered by ohm 6 · 0 0

-----Yes. Try replacing the fuse. If it looks even a little bad, it could well be bad. There may be a hair-line crack in it, or a break where you can not see it. You can also check it with a multimeter set to measure resistance. A good fuse should have about zero ohms; a bad or blown fuse close to infinite ohms. ---Jim, an amateur (ham) radio operator

2007-03-26 18:46:03 · answer #2 · answered by James M 4 · 1 0

Yes. What you want to do is pop it out and do a continuity check. Best way is to use a multimeter, if you happen to have one. But if not a simple cheapy continuity tester works fine (from the hardware or automotive store). It should have 2 leads, just hook them up to the 2 ends of the fues and it should either beep or light up an LED depending on what kind of tester you have. If you have continuity (electricity flows from one end to the other no problem) then the fuse is good. If not... toss it out.

2007-03-26 18:45:16 · answer #3 · answered by dreamed1 4 · 3 0

the fuse didn't blow but it got so hot that it melted inside
take the fuse out and brake the glass you will see that is not making contact inside the metal end
replace the fuse

2007-03-26 18:46:33 · answer #4 · answered by conejote_99 7 · 0 0

It's fairly common. In all likelihood a new fuse will solve the problem until you blow it again.

2007-03-26 18:42:02 · answer #5 · answered by Scott K 7 · 0 0

yes

2007-03-26 18:41:23 · answer #6 · answered by WDOUI 5 · 0 0

Yeah it can be and you might need as new battery supplier.

2007-03-26 18:47:06 · answer #7 · answered by memjabeana 3 · 0 0

fedest.com, questions and answers