English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

I haven't blown my speakers, that I know. They won't work for a week and then one day, the bass comes on out of nowhere. Someone told me that it could be a fuse. Does that sound right? If so, how do I know which fuse it is that is bad?

2007-03-26 10:09:41 · 11 answers · asked by this2shallpass 3 in Cars & Transportation Car Audio

11 answers

No, it can be any one of the power cables. It's not the fuse. If it were the fuse it wouldn't turn on at all. I doubt it's the hot wire.

The ground sounds like a possibility... check the location of the ground, remember to try to keep the length of the ground cable to less than 5 ft... and give it a solid and tight connection to an UNpainted bolt on the car body.

The remote turn-on wire can also cause that problem. It may not have good contact with where ever it is being connected to (fuse terminal, wiring harness, etc.). Check all your crimps all your wiring. Check the jacket of the remote wire and make sure its not shorting.

When the subs are working, take a look at the amp and see if it has power (lights on). When it is not working see if it doesn't have power. At least then you can isolate it as a problem with power and not with the audio signal from the amp to the speaker.

2007-03-26 10:23:59 · answer #1 · answered by p229 3 · 1 0

It could be a number of things, first I would check all your connections to your amplifier and to the speakers, something could be loose and my pop back into place when you hit a bump perhaps, check to see if any of your wiring is crimped or kinked. The first thing i would do, would be to re-terminate all your wires, cut them an inch or more back and then unshield the wire, it would be smart to buy new connectors at this point as well, which are only a couple bucks. Your friends are right it might also be a fuse, but doubtful, cause your subs would never work if your fuses are blown. Check the connection to the headunit and also to the battery, which brings me to my next point. If your battery is a couple years old, sometimes even less depending on the size of your amp, you might be simply running out of juice to support your car running, AND your amplifier. Try getting a bigger battery with more cranking amps, the people at pep boys or advanced auto should be able to tell you which batteries will better support electonic accessories. It never hurts to have an expensive battery, especially if its really hot, or really cold out, dont skimp on that, ESPECIALLY if you have some nasty bumps back there.

2007-03-26 10:24:59 · answer #2 · answered by Anonymous · 0 1

Fuses don't go in and out, they blow and they're done.

Some things to check:

Power wires (this includes ground) for loose connections.

The RCA signal feed for loose connection.

The remote wire for loose connection.

Look for the protect light on the amp when the event occurs, this may be due to running too low of an impedance on the amp or a sub shorted.

If nothing else, take your system to a qualified mobile audio specialist to have it checked out.

2007-03-26 10:17:27 · answer #3 · answered by Anonymous · 1 0

Ive just about had it with you people sayin that its th fuse! Its NOT the fuse. The fuse either works or it dont there aint no sometimes it does sometimes it doesnt. The only thing that woul do that is a circuit breaker and thats jus wen it trips the circuit all you do is push the lever back down. Check all your cables ( power wire, ground wire, rca cables, remote wire)

2007-03-26 11:09:24 · answer #4 · answered by Zach C 1 · 1 1

Yep, you definately have a loose connection somewhere whether it be the power wire, ground, remote, rca's, speaker wires.
Hear me now, believe me later.

Get a friend with at least a little ex. to check it out. That's your best option if you don't know what you are doing and you don't wanna fork out money for a (un)qualified audio installer to do something so simple.

Good Luck!

2007-03-28 16:36:11 · answer #5 · answered by ohm 6 · 1 0

I say go with the fuse sometimes from overtighting it. it will break the fuse. Or your fuseholder might not be making contact. One more thing it could be the ground wire if you used a lug.

2007-03-26 10:56:53 · answer #6 · answered by steveo200077 2 · 0 1

Shouldnt be the fuse, if a fuse is bad, then it should just "not working at all"
Yeah... first response is right, you should have a loose cable somewhere... power or ground.

2007-03-26 10:17:46 · answer #7 · answered by steak5959 3 · 0 1

It sounds precisely like what befell to me. Leaving out the getting the vehicle fixed and battery issues. It befell the day once I have been given my new device put in. Took it back in and ended up the sub connection has come loose and disconnected and then reconnected. It blew the fuse(actually the fuse exploded) and the amp went back to the production unit settings like somebody stated approximately me. they only replaced the fuse and messed with the amp and its all good now!

2016-10-19 23:54:16 · answer #8 · answered by ? 4 · 0 0

I would def. not turn it on until you absolutely know what's wrong with it so a improperly grounded or loose wire doesn't light your whole damn car on fire. Most likely you have a loose fuse, plug or wire. I would take it to a car electronics servicer like BestBuy because they install those.

Good luck!

2007-03-26 10:19:09 · answer #9 · answered by Anonymous · 0 1

sounds like you have a short in a wire at the speaker or at the radio or amp.

2007-03-26 10:32:21 · answer #10 · answered by ralph d 2 · 0 1

fedest.com, questions and answers