How do you fix a hole in a galvanized pipe?

Answer 1

How did the hole get in the pipe? Did it rust through? I suggest having a professional analysis of your piping system. Pipe that is rusting through, is a sign of future problems, and should be evaluated now, before "hidden" leaks cause mold, mildew, and wood rot. When you start getting moisture in the wood, termites are sure to show up, as they love the fact that they can have water and wood to eat, undisturbed, by an unsuspecting homeowner. If your house has galvanized pipe, that was installed from 1970- 1995, most pipe was imported, and is now starting to fail. This "cheaper" pipe was used all over North America, because of the price difference in domestic made pipe, and foreign pipe, that had defects, from cheaper materials, and workmanship. It isn't pleasant to hear, but it is the truth. Call a plumber to check it out! Good luck!

Answer 2

It really depends on how the hole got there. If you made the hole by hitting the pipe, or the hole just appeared, it indicates that the pipe is severely deteriorated, and you should consider removing the entire length of pipe from fitting to fitting and replacing it.

If the hole, in your opinion, is not thr esult of old piping, then use a compression sleeve to repair the leak.

Answer 3

You could also put a mechanical fitting over the leak (A rubber sleeve that has a clamp on each end). That is also a temporary fix but it would likely last you years.

Answer 4

You need to replace that section. Hacksaw through it and buy 2 nipples and a union to go back in its place. A quick way would be to screw in a sheetmetal screw with a rubber gasket. But that will leak again down the road.

Answer 5

replace the section of pipe.. dont patch it....u might have more pipe that is rotten...

if in doubt call a professional..