Car starts fine but does not rev. Nissan Help?

Question

Hi, I have a 2003 Nissan SE-R SpecV. qr25de. It starts fine and idles normal, but when I push on the gas it does nothing, it does not rev or anything. Checked codes and it says a bunch of different ones including:
P0102
P2122
P2138
P1229
P0222
P0113
Does anyone know which one would most likely cause this symptom? I was thinking the pedal position sensor sounded the most likely, but I am no mechanic. Help

Answer 1

1. First of all check that the foot feed cable has not come loose from the throttle shaft.

2. If #1 Checks OK, then replace the TPS [Throttle Positioning Sensor] located on the opposite side of where the foot feed cable attaches.

- - -

Answer 2

Your car has what is know as "Drive-By-Wire".
There is no linkage from the pedal to the throttle assembly, it is done electrically with a stepper-motor.
If there should be a failure of any part of the system, there is a possibility of catastrophic failure, and a run-away engine with the driver helpless to do anything about it. So the computer will not allow the engine to do anything more than start and idle until the system failure(s) is/are corrected.
Either find a qualified Nissan tech or tow the car to the dealer for proper repair.
The good news is that if the mileage is low enough the repairs may be covered under emissions warranty.
Check it out.

Happy Motoring