High end sounds of the system; opposite of the bass. If you want to increase the bass to the max, turn the trebble down.
2007-03-23 02:01:53
·
answer #1
·
answered by wizjp 7
·
0⤊
0⤋
I'm going to go out on a limb and assume this is a serious question...
Anyway the bass and trebble controls found in cars is basically a 2 band EQ - pretty crude. The bass will boost the "low frequencies" and the trebble will boost the "high frequencies." If you've ever seen an EQ or a graphic equilizer it's usually a 5 band EQ or a 10 band EQ, meaning the number of slider controls on it controlling a specific frequency range. Your car just has two, perhaps the bass is 20Hz - 10kHz and the trebble is probably something like 10kHz - 20kHz. If you play with it a bit it should be obvious what it is.
It will make cymbals, vocals, other high pitched sounds louder just like the bass makes the bass louder.
2007-03-23 04:00:37
·
answer #2
·
answered by Anonymous
·
0⤊
0⤋
Treble refers to the upper notes, as opposed to the bass being the low notes. You need treble to bring out the instruments with upper instruments, and yes, the lyrics. If your bass is booming too loud, the voices will be muddy. You need to adjust your treble for crisp vocals and clear instrumentation. A hot booming bass is fine, but that is only one element of a song which has been finely balanced in the recording studio. Don't cheat the treble.
2007-03-23 02:07:07
·
answer #3
·
answered by brig1gand 3
·
0⤊
0⤋
treble is for the higher notes and sounds, bass for the lower end notes - they actually balance each other out and can be adjusted according to the song for an optimal sound - but if you use a subwoofer - the treble will not come out of the sub - just your regular speakers and help balance the sound
lowering the treble WILL NOT increase the bass - just eliminate the high tones and make it sound like more bass - but the sound will actually be distorted bass because it is not balanced out................
2007-03-23 02:02:27
·
answer #4
·
answered by T F 4
·
0⤊
0⤋
The 'Bass' setting is like a volume for the low-frequency (why haven't I seen this word yet?!?) 'sounds' that come from your speakers. The 'Treble' setting is like a volume for the high-freq. 'sounds' that come from your speakers. Unless you have alot of power going to your doors speakers (like most of you people on this site), then turning it all the way up is almost a must for clear sound. To have all the power (250wrms on 80Hz and up), this just gets aggravating, not to mention kills your hearing!
2007-03-26 13:25:18
·
answer #5
·
answered by ohm 6
·
0⤊
0⤋
bass, is something that your subwoofers produce, but treble is just absolute opposite. twitters produce treble.
it's not for the lyrics, but if you're listening to metal/rock or rap/hip hop, you may not get clear sound with lots of bass on high volume. that means that you need more treble.
2007-03-23 02:24:17
·
answer #6
·
answered by Anonymous
·
0⤊
0⤋
The treble increases the mids and highs, what you hear outta your tweeters, hopefully you have tweeters (for the chhh chh chhh part of the music)
2007-03-23 02:07:59
·
answer #7
·
answered by Anonymous
·
0⤊
0⤋