Anyone have ideas on how to copy the look of a sliding, shoji screen door for cheap?

Question

So far all I have is to spray mirrored doors with "frosted glass" paint and add thin pieces of wood to square off parts like a shoji screen. Anyone else have a better idea? Thanks.

Answer 1

I think that sounds like a good idea... you might spray w/ clear frost sealer (like for crafts). Just glue the black strips on top.

Answer 2

The fact that each the door and the display are performing up even after cleaning the track is just a little atypical, however let's start with the reveal. Lift it up to dispose of the monitor door from the track and lay it down to compare the rollers. Commonly they can get clogged with debris and cleansing the rollers may just restore ease of action. Add a drop of oil to each and every wheel axis for lubrication. Typically the rollers can get bent or broken and have to get replaced. The glass door is a little more troublesome. There's much more weight involved and the rollers can put on out or go out of alignment. As the rollers put on, the bottom can begin dragging. In order a first step, most sliding doors have a mechanism called an adjusting screw placed on the backside of the door ends. Flip this screw to raise or lessen the roller on that end. Provide the screw a flip and scan to peer whether the door slides less complicated. If the door turns into even tougher to open, flip the screw within the opposite course. After a little bit of adjustment, the door will have to roll less complicated without rubbing on the bottom monitor. If that does not work, the sliding glass door will have got to be removed and the rollers cleaned or replaced. Caution: the door will be heavy so in case you DIY you might have considered trying a helper. You too can recollect hiring a expert to fix each the door and the screen. Any better metropolis could have people who do that variety of labor. Look online or in the phone book for patio door carrier and repair.

Answer 3

I went with a kind of paper draftsmen use, I forget what its called, but it feels like plastic. You can get it at arts and crafts stores, and it comes in poster size. You can only cut it with a razor, and even then its hard. I've had people miss my dart board and hit it, and the paper never ripped or torn.