I have a 2001 blaster. All done up but when I start it and give it gas it boggs out then stalls.I cleaned air filter,new plug,adjusted air screw. This problem started after I got a new frame and exchanged all parts to new frame. Now this. It starts but it pops and pudders then stalls when I give it gas. Please help me. Could it be wrong wireing? It ran like A top before the swap, no problems at all.
2007-03-17 10:23:21 · 3 answers · asked by Anonymous in Cars & Transportation ➔ Motorcycles
Check the spark plug.
Check that the intake and air box manifolds are making a good seal to the carb.
Check that the air filter is installed properly.
Make sure the air box cover is making a good seal and the intake isn't clogged.
Check the oil line from the pump to the carb for damage and it's making a good seal to the carb.
2007-03-17 11:51:52 · answer #1 · answered by guardrailjim 7 · 1⤊ 0⤋
at the starting up your spelling is atrocious, and your disgusting bathing room habit don't have any effect concerning to this question. #a million Its no longer accessible to strengthen the bore of a 2 hundred cc to 250 cc except a sparkling cylinder replaced into used. #2 the rod bearing is frequently shot #3 the Blasters are said for mess united stateson both stroke oil injection pumps and the smart Blaster proprietors get rid of the oil pump and combine the oil and gasoline in the gasoline tank
2016-11-26 19:21:41 · answer #2 · answered by ? 4 · 0⤊ 0⤋
even though it doesn't sound like an electrical problem check where the coil and ground wire is mounted, the paint should be sanded off. it sounds like your getting to much fuel, check the throttle cable and float level, possibly a stuck choke
2007-03-17 17:27:29 · answer #3 · answered by mr2mike89 2 · 0⤊ 0⤋