I have an AXXESS 2 channel line output convertor, and i am trying to hook it up to my stock stereo and an Xplode 1200w amp. I tried to connect it to my speaker wires and now my speaker doesn't even work. The whole wire to the box doesnt work. What do i do to attach the convertor and how can i get my speaker to work again?
2007-03-15 17:12:09 · 2 answers · asked by Snoman 1 in Cars & Transportation ➔ Car Audio
It's impossible to say without knowing exactly what you did. It's unlikely that you damaged a speaker by connecting a LOC into the speaker wire, but you may have cut the wire and cut off the sound to the speaker, or if you tried to connect at the speaker itself you may have damaged it; or if you shorted the wire you may have damaged the factory amplifier. I'd say remove everything, patch up the wire and get it as close as you can to the way it was, then see if everything works.
The factory amplifier in this vehicle is located under the trunk lining on the left side, mounted to the back of the rear wheel-well. All four speaker outputs can be found there and it's usually the easiest place to tap into speaker wires.
2007-03-16 01:17:35 · answer #1 · answered by KaeZoo 7 · 1⤊ 0⤋
You totally fried your speakers 1200 watts is way to much for your stock speakers. Replace them with speakers that can handle 1200 watts or is 600 watts per channel?
2007-03-16 03:55:20 · answer #2 · answered by Curious George 4 · 0⤊ 2⤋