98 honda accord alarm install question on parking light wire What wire do i tie into?

Question

Hello,

I have a98 acord and am installing a autopage 750 alarm... I have it all installed, execpt for the white wire that goes from the out from the alarm that is to be connected to the parking lights.

The alarm has an internal relay, so this wire can go to the parking lights directally. I know that autopage has a helpline, but they cannot give in specific "which wire to which info"

My question is has anyone installed an alarm onto a honda, and if so, do you know what parking light wire you tied into... i.e. where was the wire,....if I tie into the wrong wire on the honda factory wiring, I may cause a failure in the factory switch or something else that is not good.

Thanks in advance dave

Answer 1

The positive (+) parking light wire is red/black at the fuse box on the driver's side. Test it with a multimeter; it should read 12 volts with the parking lights on, 0v with the lights off.

Answer 2

1998 Honda Accord Security Information
Constant 12V+ White Passenger's Side Fuse Panel or Ignition Harness
Starter Black/White Near Heater/AC Fan Motor
Ignition Black/Yellow Ignition Switch Harness
Ignition 2 White/Black Ignition Switch Harness (ABS Light)
Accessory Yellow Ignition Switch Harness
Tach Blue Distributor
Brake Switch Green/White Brake Switch
Trunk Release White/Red (+) Driver's Side Grey Molex
Trunk Pin Orange (-) Driver's Kick GREY Molex Connector
Parking Lights Red/Black Fuse Panel
Head Lamp Blue Left of Column Blue Connector
Hood Pin Yellow (-) Passenger's Side Green Connector
Factory Disarm Blue Driver's Door
Door Trigger Black/White (-) Passenger's Side Fuse Panel
Door Lock Black/Blue or Black/Red Panel Passenger's Side near Door
Door Unlock Orange (-)
Horn Wire Light Green/Blue Passenger's Side Fuse Panel