How do you lay floor tile in a small bathroom?

Answer 1

First you need a proper substrate. If the floor is already concrete then clean and level it. If it is wood then you need to put down some Dura rock or other tile backer. Then using a chalk line grid the room according to the size of tile you have. Let's say they are six by six inch's. Create a center line by measuring off what you think of as the straightest wall. Then use a framing square from the center of that line to create a perpendicular line. These are the four quadrants of the room. Measuring off the lines mark every 24 inch's and snap new lines and you have your grid. each grid will hold 16 tile. Any cuts on the outside edge can be figured out and made at this time but use markings on the back to remember where they go. I like to start with #1 in a corner and work clockwise. When everything is prepped, then you spread your thin set mortar, using the recommended trowel for your tile size, in one grid square at a time and firmly bed each tile in the mortar using a float to tamp them down. Work your way backwards out of the room like this. Next day, grout and clean.

Answer 2

Both glazed Bathroom Ceramic Tiles can be laid directly onto a concrete floor, as long as the floor is dry and in good sound condition. After the floor has been nicely prepared what now? Well, the next step is to start laying out those tiles of yours. If you want the end result to look professional, then careful setting out of the tiles will be required.

Now here comes the part of installing the Bathroom Ceramic Tiles which isn't a very complex job. Instructions on how to lay the Bathroom Ceramic Tiles, arrange, cement and other attributes are all over the Internet or home improvement guides. At the onset, you need to find the center of the floor and lay the tiles from there as it creates a feeling of visual symmetry. When arranging the tiles, you must make sure that the Bathroom Ceramic Tiles design is laid such that it creates continuity in the design.

And yes, ensure that your tiles blend with the color of the wall or the general theme of your bathroom wall and the fittings. You could also install a tile heater to give your feet the warmth as you step on it, a very good feature to have especially during winters or to avoid that sharp chill you'd encounter early in the morning. You could also use a relatively warm color shade to offset the cool look of the bathroom fixtures.

Check out http://www1.webng.com/bathroom plans for more information

Answer 3

pull up the old flooring. Prepare the base floor - you can get the stuff at Home Depot.

Secret: when you lay the tile start in the center of the room and lay it out to the walls this is so your tiles will look good on the parts most people see.

First you glue the tiles down with some cement/grout stuff and you can also buy spacers at hardware stores so you get a more uniform look. After the glue/cement had set pull up the spaces and put in the grout.

Tip: so not use white of light colored grout.

Tip: Use a sealer on the grout too

Answer 4

I usually find the center of the main area in a long skinny bathroom. Snap a chalkline from one end of the room to the other. Take measurements to each side of the line. Dry fit or measure the tile you will be using to see if the distance from the centerline will cause small pieces against the sidewalls. You can adjust the tile to prevent this.position from there to

Answer 5

the same as a big bathroom except with more tiles

Answer 6

With the help of a tile fixer.

Answer 7

You have to lay sheetrock first. Put thinset on the sheetrock and then add the precut tiles. Once dry work in the grout.

Answer 8

What kind of tile? Vinyl or ceramic?

Answer 9

Check out diynetwork.com http://www.diynetwork.com/diy/pac_ctnt/text/0,2019,DIY_14161_18733,00.html

Answer 10

My advice is hire a pro for this job.