I have looked all over and i cant find it
2007-03-03 12:18:52 · 10 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ GMC
The only Duramax heater plug I've ever noticed was on the passenger side, between the battery and the headlight. I'm not disagreeing with the guy who builds 'em, or the guy quoting the manual, but it seems it could be on either side...
2007-03-04 02:41:06 · answer #1 · answered by InjunRAIV 6 · 0⤊ 0⤋
Duramax Block Heater Cord
2016-11-12 21:10:58 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Turn off the engine.
Open the hood and unwrap the electrical cord. The cord is located on the driver's side of the engine compartment, near the power steering fluid reservoir.
Plug the cord into a normal, grounded 110-volt AC outlet.
2007-03-03 16:13:42 · answer #3 · answered by jeep452 2 · 0⤊ 0⤋
Eric is right. It is on the right side of the engine (passenger side), at the back lower edge of the air filter box, down along the frame. You will see a wire that goes from the engine, straight over to the frame, about half way back.
P.S. Did you try reading your owners manual? It should say in there.
2007-03-04 11:08:09 · answer #4 · answered by zaney 1 · 0⤊ 0⤋
Heater Cord usually located behind the dashboard on front passenger side.
2007-03-03 13:00:06 · answer #5 · answered by ll_aiia_ll 1 · 0⤊ 0⤋
Should be bundled up on the frame left side of motor. This is where they route them at the assembly plant I work at. Take the zip tie off and finish running it out the grill or just under the grill.
2007-03-03 13:30:10 · answer #6 · answered by skip1960 4 · 0⤊ 0⤋
if you,ll look on the left side of the engine it will probably be there probably with a wire tie around it,its usually on that side though and will either go in the side freeze plug or the front one,what you can do is pull it through the grill,and fix it to stay in there and it will be out of sight but you can get to it easy,good luck with it.
2007-03-03 14:27:47 · answer #7 · answered by dodge man 7 · 0⤊ 0⤋
my paintings truck is an '06 duramax and its block heater twine replaced into zip tied to the physique rail on drivers ingredient basically decrease than the pinnacle easy as "pbleek" says it is going to constantly be in that well-known section. 25 years of wrenchin' , who study the paintings orders to you "djack"?
2016-12-14 10:00:23 · answer #8 · answered by Anonymous · 0⤊ 0⤋
right side of engines guys, (passanger side). Straight down from the airbox taped to harness on the frame.
2007-03-03 14:38:33 · answer #9 · answered by Anonymous · 0⤊ 0⤋
thank you guys! your comments were VERY helpful
2014-03-05 10:17:17 · answer #10 · answered by Anonymous · 0⤊ 0⤋