have 350 buick from 1970 lesaber stock engine has 10.25//1 comp and is rated at 315 hp.. want to put in my jeep, anyone done a swap like this need some details
2007-02-23 11:29:48 · 3 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Jeep
That engine is pretty wide to stuff into that engine bay. It would be a real sleeper at the stop lights if you can make it fit. I saw a picture of a viper engine in a cherokee so Maybe? Don't know how much hacking and cutting had to be done to make that fit.
Check out the adapter you will need to go from the trans to the driveshaft. You will most likely need to alter the driveshaft somewhat to make it fit and you will need to fabricate mounts.
Good luck, it sounds like a big job that I would not want to tackle....
2007-02-25 15:41:25 · answer #1 · answered by Anonymous · 0⤊ 0⤋
you are able to continuously pass away the motor vehicle in all-time 4 wheel force. reckoning on your pass case, this could the two be your purely option for use on paved roads, or you are able to even have the alternative of 2WD. in case you have a 2WD determination, moving into it quite is going to supply a (very) minimum gasoline economic equipment benefit. independent is in simple terms for flat-towing the motor vehicle and thoroughly decouples the drivetrain from the transmission. the only way you're moving in independent is via pointing it downhill or getting out and pushing. ;)
2016-12-17 17:26:52 · answer #2 · answered by ? 3 · 0⤊ 0⤋
that would be a very tight fit , kenne bell might have a kit , i would measure it to see if it is at all possible without major surgery
2007-02-23 13:58:34 · answer #3 · answered by sterling m 6 · 0⤊ 0⤋