i just dont want to miss anything. thanks.
2007-02-19 14:06:24 · 5 answers · asked by firestarter 5 in Sports ➔ Outdoor Recreation ➔ Hunting
From a fellow beretta man...Heres the prefered method for the 92... clean the gun..remove all socleaning solvents(wipe dry) Points to place a drop of oil--Locking block, a drop on each of the "ears", and a drop on the contact points where it meets the barrel....slide rails(these should have a film on them, i use a patch with a few drops of oil on it and wipe them down. A drop on the hammer pin contact point. also every once in a while i put a drop on the inside of the mag release button. In addition I like to leave a light bit of oil on all of the parts, but not too much, because it will collect dust. the 92 is very reliable, I have put 2.5K through mine without a single hicup. Also check out http://www.berettaforum.net/vb all the beretta info you could ever ask for. hope to see you there
-sleepyweasel
2007-02-19 17:41:03 · answer #1 · answered by Heidi 3 · 1⤊ 0⤋
Use grease on the slide rails and locking block, oil everywhere else. Grease will not evaporate or run off during use. Just use a thin film, and wipe off any excess to keep it from attracting too much dust.
A good way to tell if a part needs lubrication is to look for wear or shiny spots on mating surfaces. If it's shiny, lube it.
Tetra Grease or Permatex Anti-Seize Lubricant are the ones I usually use, and have had no trouble with gumming up or dust for 2,000 rounds now.
2007-02-20 11:48:56 · answer #2 · answered by grenadier8408 3 · 0⤊ 0⤋
the only place I lube mine while shooting is along the frame rails - the groove where the frame and slide come together, and only very lightly....excess oil will burn off from the powder ignition and gum things up.
I also store dry - the way we did in the Army. Clean thoroughly and store dry, apply oil before shooting but not for storage because the oil attracts dust, which turns oil into a gummy mess.
2007-02-20 00:01:35 · answer #3 · answered by Ohari1 3 · 0⤊ 0⤋
Oil the slide rail I would also put a drop or two by the hammer. When your done shooting clean and store dry or if you have a good gun case very little oil.
2007-02-20 00:37:25 · answer #4 · answered by Rambo 3 · 0⤊ 0⤋
I agree with grenadier, use something other than just oil, there's alot better stuff out there.
2007-02-23 20:38:20 · answer #5 · answered by Jeff D 1 · 0⤊ 0⤋