this is a 8 zone panel
2007-02-14 15:33:29 · 5 answers · asked by Qif007 1 in Science & Mathematics ➔ Engineering
Extinguish the fire
2007-02-14 15:49:51 · answer #1 · answered by Brain of JFK 2 · 0⤊ 0⤋
I am not sure I totally understand what you are asking.
The simplest way is to disable the system is to cut the power to the panel.
Disconnect the battery leads (if so equipped), then kill the AC power by either turning off the breaker that feeds the panel, disconnecting the panel from the transformer, or carefully disconnecting the AC HOT wire that feeds the panel. I don't recommend the last one if you can avoid it.
When powering back up, always start by restoring AC power first, followed by the batteries. (If you power up or down from DC power, it can be hard on the circuitry and you could cause damage to the system.)
2007-02-15 12:47:19 · answer #2 · answered by todvango 6 · 0⤊ 0⤋
If the sensor works by breaking a circuit then you could shunt the connectors of the two wires that come from the sensor to the panel. If the sensor works by making a circuit then you could just cut the wires or pull one of the wires loose.
2007-02-14 23:52:34 · answer #3 · answered by anonimous 6 · 0⤊ 0⤋
not enough information to answer. Also is the single sent to the station rather than just the building. Is i part of a security system...
2007-02-14 23:42:08 · answer #4 · answered by matt2571483 2 · 0⤊ 0⤋
It is usually deactivated using controls. It can be deactivated by switch off it.
2007-02-14 23:42:45 · answer #5 · answered by Lekha S 1 · 0⤊ 0⤋