how would i put a rubber worm wriggler on a hook?

Answer 1

if u are talking about a plastic worm.............
first u need to get some offset hooks and worms.
next u stick the point of the hook through the head of the worm,no more than a 1/4".turn the hook until it comes out of the worm.next,run the worm up the hook to and over the offset in the hook.next u turn the worm around the hook to where the bend of the hook is towards the worm.next u put the hook into and through the worm again being careful not to leave a bend in the worm above where the hook goes back into the worm.next u just bury the point of the hook to where it is just under the skin of the worm.
there u go........ready to fish.

Answer 2

Just the same way you'd put a real worm on it !

??

Answer 3

.02 hook, make is look semi-normal so you can wiggle it.

Answer 4

cant you just get a jiggy?