we have replaced the starter cilanode, rewierd, we replaced every thing we could think of and its getting fuel it sounds like its going to turn over but nothing happens and another person told us there is a nutaral safety switch under the stirring wheel but we cant find anything please help if we cant fix it will sale parts
2007-02-12 15:32:17 · 6 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Ford
it has fuel has spark and has air still wont start the starter motor is turning we have tryed bridging the cilinoide but nothing seems to work we also have power in the car we have checked the wiring and also have had every part replaced that we can think of from the starter cilinoid to the chip and we have checked all of the wire connectors but still we have no luck so if anyone has gone through this or knows what to do please help thanks....
2007-02-12 16:00:55 · update #1
Check the electricals there might be a problem burning the fuel down.
2007-02-12 15:40:33 · answer #1 · answered by Puzzledmind 3 · 0⤊ 0⤋
i own a repair shop,and the neutral safety switch is part of the ignition switch on this one,it may have went out on it,if it did it will usually start if you actually put it in neutral and hold the brake and try and start it,if you don't get nothing after trying this id say the switch is bad on it,its about time though,its a 90 model and it lasted this long so it done pretty good,but you can turn the key on,and jump it over at the the solenoid switch,and see if it starts this way,if it does,it definitely needs a new ignition switch,like i said it and the neutral switch are built together ,good luck with it ,i hope this help,s.
2007-02-12 15:40:37 · answer #2 · answered by dodge man 7 · 0⤊ 0⤋
If its cranking over, its not the nutruel saftey switch. It sounds like your not getting spark. Take one of the spark wires and put a screw driver in it. Place the screw driver over the top of the engine on the intake. Have an assistant crank the engine and see if your getting spark. If you are, you probably flooded out the engine. If not, check the coil and wiring to the coil.
2007-02-12 15:43:30 · answer #3 · answered by David B 2 · 0⤊ 0⤋
check battery, check battery connections. check ground. check connection on starter. check that starter has not come loose from block of engine since starter needs the ground from being tight against it. go ahead and put a battery charger. pull spark plug wire off and check for spark. spray starting fluid in throttle body.
2007-02-12 15:43:00 · answer #4 · answered by Anonymous · 0⤊ 0⤋
simple the ignition chip is burnt out you need a new one it is on the side of the distributor ask the parts man if they got the tool to get the two screws out it is a goofy size remove and replace and it shoud go
2007-02-12 15:51:41 · answer #5 · answered by goat 5 · 0⤊ 0⤋
once you obtain stuck you obtain the exhaust plugged. each and each and every of the dirt drained into the tailpipe. you want to get it out. both dismantling the exhaust or alternative. attempt to get the tailpipe off and attempt that .then take muffler off and keep attempting till it runs solid. then rinse out or through recent
2016-12-04 02:54:53 · answer #6 · answered by ? 4 · 0⤊ 0⤋