Which engine? The 3.0L OHV V6, or the 3.0L DOHC 24 valve V6? Leave me your FULL Yahoo e-mail address if you want me to e-mail the diagram to you.
2007-02-04 13:04:11
·
answer #1
·
answered by Anonymous
·
0⤊
0⤋
relies upon... Taurus is front wheel force. Engine and transmission are fixed on a sub physique. Crown Victoria relies on the previous variety of yank layout automobiles with rear wheel force, front engine and a force shaft. The taurus has a v6 and the crown vic could be a v8. in actuality from previous journey and information the taurus has the weaker transmission. The crown vic has an older variety of transmission in spite of the incontrovertible fact that it relatively is a shown layout. to repair the transmission on the taurus you may drop the subframe (motor and trans) to get it aside. For the crown vic you undo the bolts pull the force shaft and drop the transmission out. The crown vic is countless hours much less labour. in my opinion i might like the crown vic because it relatively is in keeping with shown technologies that Ford is familiar with (are you able to attend to to pay for the gas?) and that i be attentive to i will get components for a incredible cost. For gas financial device the taurus wins because it has an particularly aerodynamic layout.
2016-10-01 10:44:52
·
answer #2
·
answered by ? 4
·
0⤊
0⤋
pull the wheel off and splash shield makes alot easier to access from the bottom of the car dust off your metric tools ford techs get 1/2 hr to do the job. so it should take a back yard tech about an hr to replace one.
2007-02-05 02:07:21
·
answer #3
·
answered by I race cars 4
·
0⤊
0⤋
first, push serpentine belt tensioner, and remove belt, disconnect the battery, then disconnect wires to alternator, loosing & take out the bolts in the bracket that are holding alternator in place..If you have and adjuster bolt, loosen that one first..
2007-02-04 14:59:54
·
answer #4
·
answered by gotspeed7883 3
·
0⤊
0⤋
Replace the Taurus. Keep the alternator!
(sorry to be so sarcastic!!!)
2007-02-04 13:03:12
·
answer #5
·
answered by waynebudd 6
·
0⤊
2⤋
all i can say is have fun its a ***** unless you have the right tools
2007-02-04 14:04:12
·
answer #6
·
answered by tommy j 1
·
0⤊
0⤋
owners manual.
2007-02-04 13:01:22
·
answer #7
·
answered by John G 2
·
0⤊
0⤋