How do you mount a photo or a computer print to a wooden plaque? Tried spray adhesive but the paper peels off

Answer 1

Try sanding the board first , then coat with sanding sealer. (Basically clear thinned shellac) Let it dry and use 3M spray adhesive following directions carefully . You may want clamp the finished work by putting a weight over the print - Use a sheet of wax paper over it and put weight on it ( a stack of books or another board the same size with weight on it ) When mounting the photo, make sure all air bubbles are removed using a clean rolling pin or a squeegie or even a sponge.

Answer 2

Make sure if you use spray adhesive like 3M that you spray BOTH the back of the paper and the board, let them dry and then attach them. After that, you could spray polyeurthene over it for a a permanant finish. I say spray becasue poly is hard to paint without streaks.

Answer 3

relies upon on high quality you go with. i might advise goto workplace depot and purchase Epson photograph printing paper and supply it a attempt. they are no longer that expansive. There are distinctive variety of papers, like tender and different types. it somewhat is up on your style. i think of %. yours in workplace depot, there you will even see pattern print outs and you will touch and experience the way it somewhat is and %. the single you like,

Answer 4

resin for long lasting, shelac for chepper.varithane is the answer

Answer 5

try wallpaper adhesive.

Answer 6

shellac