I have to give rides to someone who can't wear the belt due to a medical condition and it is really annoying.
2007-02-01 11:25:36 · 8 answers · asked by dierboy 3 in Cars & Transportation ➔ Car Makes ➔ Ford
You didn't say what kind of Ford... But read your owners manual.. it tells you how to shut off the beep beep agrevating noise... basically lots of buckling and unbuckiling of the seatbelt at a certain time to clear it.... A lot cheaper than having the Ford dealer do it (who depending upon the dealer, will either charge you to do it electronically or do it just the way I said...)
2007-02-01 12:21:16 · answer #1 · answered by gearbox 7 · 0⤊ 0⤋
in every later model ford i have seen there is a small sensor under the seat. that comes from the seat belt latch, the sensor plugs into a wiring harness halfway to the floor. just unplug the wireing harness by pushing down on a little button type thing on the harness and pull. But be warned the air bag light might come on.
2007-02-01 18:15:26 · answer #2 · answered by Chris 2 · 0⤊ 0⤋
1. See if there is a sensor or something under the seat and try disconnecting it.
2. Buckle the seatbelt and have them sit over it.
2007-02-01 11:31:28 · answer #3 · answered by m k 5 · 1⤊ 0⤋
Check your service manue first, and ask your dealership to see if they will do it. Most of the time they won't do it, cause of the safety conern but you can try it. I am not sure if the seatbelt light will be on or not, but make sure you ask the dealership about that too.
2007-02-01 14:07:14 · answer #4 · answered by DavidC11 2 · 0⤊ 0⤋
check your owner's manual. It should give you the details of how to do it. It involves the emergency brake, turning the ignition switch off and on a set number of times plus the headlight switch. I can't remember all the details just off the top of my head but I'm sure they will be in the manual.
2007-02-01 17:48:41 · answer #5 · answered by Fordman 7 · 0⤊ 0⤋
You have to plug the seatbelt in and then unclick it, stupid, annoying beltminder! I get the concept to try to make people buckle up but you know how annoying that is!
2007-02-01 13:44:52 · answer #6 · answered by coreboy7 3 · 0⤊ 0⤋
both are wrongyou have to take it to a ford dealerthey have to disable it through the instument cluster module (ICM)
2007-02-01 12:02:59 · answer #7 · answered by Tim B 4 · 0⤊ 0⤋
usually some where around the fuse block it should pull out
2007-02-01 11:30:42 · answer #8 · answered by rottman 2 · 0⤊ 0⤋