It's a circly thing that has riply edges to give it a good look.Just tonight i tried getting it out it was stuck so i got a knife and edged around it to loosen it up.Then half spaterred on to the dish and i was so sad.=(PLease give me suggestions!I don't want to fail again
2007-01-28 17:00:43 · 8 answers · asked by flamingpignose2 2 in Food & Drink ➔ Cooking & Recipes
Put a plate large enough to cover the open bottom, and hold tight as you flip it over. Keeping the tightly in place, slowly run warm/hot tap water over the mold for a few seconds, careful not to let much get under the mold between the plate. It should plop right out with a few taps.
2007-01-28 17:28:47 · answer #1 · answered by DesignGeek 2 · 0⤊ 0⤋
First, spray the mold with non-stick spray. Then after the mold has jelled, dip it in a pan of hot water almost to the top of the mold. Leave it in for about a minute at a time take it out and shake it gently.this may take a couple of tries. If it still isn't working, use a small sharp knife just to release the edges about an inch all around the mold re-dip and shake gently until it seems loose. Put a large plate over the top of the mold, upside down, and flip the whole thing over. Holding the mold and plate, shake up and down and it SHOULD release onto your plate!
2007-01-29 01:40:59 · answer #2 · answered by Mio K 2 · 0⤊ 0⤋
Have ready a pan of luke warm water,large enough to take the fluted pan,a quick dip in & out will loosen the margin enough to let it slide out.Repeat the dip if needed but don't immerse too long or the jello will start to liquify & spoil all your efforts.
2007-01-29 01:13:12 · answer #3 · answered by dee k 6 · 0⤊ 0⤋
Oil the pan first with an oil that has a very light taste. (Crisco has almost no flavor) it will slip out easily. If you already made it and it is already stuck -float or set the bowl in some hot water for a few minutes that should loosen it up.
2007-01-29 01:22:20 · answer #4 · answered by Raven A 3 · 0⤊ 0⤋
Dip the mold in hot water just long enough to loosen the jello but not too long or it'll melt.
2007-01-29 01:16:07 · answer #5 · answered by Georgewasmyfavorite 4 · 0⤊ 0⤋
spray it with a little cooking spray next time and dip it in warm water for a few seconds it should pop right out. i always do jello molds for the holidays they are so much fun
2007-01-29 01:06:40 · answer #6 · answered by felixnstacey@sbcglobal.net 2 · 0⤊ 0⤋
soak bottom of pan in hot water than turn it over
2007-01-29 01:17:17 · answer #7 · answered by Anonymous · 0⤊ 0⤋
tap the bottom and it comes right out...
2007-01-30 12:02:02 · answer #8 · answered by brown_suga002 3 · 0⤊ 0⤋