hodwdo i turn the idle up on my 94 camry? with the little set screw under the trottle cam were the gas feed cable is? or do it with the cable adjustments?
2007-01-25 01:58:29 · 5 answers · asked by british racer 1 in Cars & Transportation ➔ Car Makes ➔ Toyota
its got new plugs wires roter button cap...it idles fine till it get s warm then it drops to about 600 at idle in gear? in nuteral its about 800 at 600 it causes the steering wheel to viberate a little..it gos away if you push the gas and make it idle to about 800 rpm?? think i should change that idle solenoid? first?
2007-01-25 02:27:44 · update #1
try having the throttle body cleaned,followed by an induction system cleaning,that starts at the trottle body.if that does not work,you will need to have the idle air control vavle replaced.it is under the throttle body,where the accelerator cable hooks to the throttle valve.the idle is non adjustable.changing it would be a mistake.turning the set screw might help,but it will not solve the problem.it would get worse and do the same thing later.
if a mechanic is willing to spend some time on it,he can free the IAC,spray a cleaner in it and let it sit.start engine and repeat until better.
2007-01-25 05:43:03 · answer #1 · answered by JB 3 · 0⤊ 0⤋
The idle speed on a Camry is not adjustable. So to say. By playing with the fuel/air mixture you can make the idle speed rise or fall, but you will also make the emissions rise and fall as well as performance.
If you car is holding a constant idle too low then you have a problem elsewhere.
When did the car have the last tune-up and performance check?
Nice car by the way... always like them camrys
2007-01-25 02:16:00 · answer #2 · answered by shovelkicker 5 · 0⤊ 0⤋
None.
The idle adjustment is made by the computer itself using the idle solenoid. (attached to the throttle body). Adjusting the idle using the cable or the Little screw can trigger a "Closed Throttle position sensor"Trouble code on the computer.
If your Car is not idling properly is due:
A stuck or defective idle solenoid (also called Idle control valve)
A vacuum leak in the induction tract. either a gasket or vaccum hose.
2007-01-25 02:23:13 · answer #3 · answered by Wrenchmeister 3 · 0⤊ 0⤋
there is no idle adjustment , try cleaning your throttle body that's whats causing low idle speed.
2007-01-25 10:54:56 · answer #4 · answered by Anonymous · 0⤊ 0⤋
im thinking it must be a pushrod. my vehicle knocked to and it became the pushrods or the lifters i think of. examine it out earlier your engine gets tangled up. i think of in case you maintain driving it one ought to snap and itll bypass via your engine and youll ought to purchase a sparkling one. i think of that would ensue in any case
2016-11-27 01:03:31 · answer #5 · answered by adule 4 · 0⤊ 0⤋