I have a natural, toungue and groove, dark pine ceiling from the 1950's that I need to lighten up. I would like to white-wash it but dont know how. Anyone done this before? Thanks.
2007-01-23 09:06:50 · 3 answers · asked by Lila L 2 in Home & Garden ➔ Decorating & Remodeling
If this is a beadboard, it is almost impossible to sand correctly due to the beads (or grooves). This also does not count the value of this type of board as is, historically. Also historically, if it is painted, it is full coverage.
If you do use choose to cover it, use vinegar and water to wash clean, and allow time to dry. Use a primer tinted to the shade of white desired, then water down a bit (for white wash affect) to brush on, or rag on. Depending on the age of the wood, finish, and saturation of oils and smoke (if around) over time, will determine the final color and coverage.
2007-01-23 14:23:05 · answer #1 · answered by ksuetx 2 · 0⤊ 0⤋
There is a stain color called platinum, it's white. Use that. You will probable have to sand the wood if it is finished so the stain can absorb. This is a good way to go because when you varnish, some yellowing will occur over time and this will kind of counter-act the yellowing effect. Good luck.
2007-01-23 17:18:46 · answer #2 · answered by tim r 3 · 0⤊ 0⤋
Go buy some White Duct Tape, and cover the wood with it... Then you can always take it back off if you don't want it...
2007-01-23 18:43:17 · answer #3 · answered by gjerstadkid 2 · 0⤊ 1⤋