can i load a software ( autocad , corel etc ) onto a usb drive and then operate it on another computer?

Question

can i copy the software files onto a usb storage device and then use that usb to connect it to another computer and operate the softare through the usb

Answer 1

I think you'll find that programmes like that would make a registry entry at the time that you install them. Therefore, if you were to try using the usb in another computer it wouldn't work because it was missing the registry entry.

Answer 2

No you cannot
The only way you can to save storage is to rename the destination folder as your USB disk (while you r installing the software) but that will only work on that specific computer.

The reason behind is when you install these programs (Corel DRAW, AutoCAD, Photoshop etc) they share DLL's (Dynamic Linked Libraries) and some registry keys shared with windows system files which are installed directly into windows directory so when you try to run the software via USB these files are not linked with that software program which will give you error message file not found.

Answer 3

Not really, as windows normally search for some DLL and registry information and those need to be installed. So even if you copy the full installation directory it will more or less certainly fail to work on another computer.

However, some flash memory makers created a software which should just allow you something similar. I didn't tested it however:

http://www.sandisk.com/Products/Catalog(1167)-NEW__SanDisk_Cruzer_Titanium_USB_Flash_Drive.aspx

Answer 4

nicely, it may be much less complicated to purchase an exterior force, yet while that's no longer an decision, this is what you're able to do. this is assuming which you have a on the spot community What we could do for this answer is basically proportion the optical force in one workstation over the community on your acer. for many this is the least complicated approach using fact maximum clientele at the instant have a community obtainable, and assuming there’s a community there’s probable a workstation with an optical force linked to it. First you could load the CD/DVD into the optical force interior the workstation. Now pass to My workstation and top click on the force with the loaded media, click properties, navigate to the Sharing tab (word in case you haven’t finished this in the previous it ought to grant you a warning which you shouldn’t try this except you recognize what you’re doing, click the message to proceed). examine the proportion this folder on the community container, provide it a acceptance like Shared Optical force (or a acceptance of your decision), and hit ok. > word: From this factor forward any workstation on your community would be waiting to get right of entry to the shared force. If that's a difficulty be confident to maintain on with the stairs above and uncheck proportion this folder on the community, to take it off. Now get on your Acer and make confident that's linked to the community. get right of entry to My community places, and click upload A community place, use the wizard to function the optical force you chosen to proportion. Now that that's shared you are going to be waiting to get right of entry to it from My community places at any time (while your Acer is linked to the community), and it relatively is going to immediately refresh in case you turn the CD, if it doesn’t do a top-click, and hit refresh and the information could replace. while you're attempting to place in utility and are used to vehicle-run, double click the Setup.exe record or such as initiate installation.