Where can I get instructions on how to tape and mud drywall?

Answer 1

Let me help: Make sure the drywall is set at a small indepth seam, add mud / you can purchase a tape that has fiberwith one side sticky place into center apply a wide 4" mud to cover tape. Next day use a wider 6" put a fine layer just enough to have center even, don't worry about the edges because that is the most area to sand avoid the cento too much. Corners is tricky best way is to apply mud one side then the other the next, never go wrong this way. Remember studs are 16" apart mark a dot on floor for location of suds so you can't screw wrong place. Ceiling goes on first at all times. ( you place dot on ceiling if you which) Coner tape has a metal strip running in both center inner seam, this can reduce time in mudding of the strength of tape. If you have screws the might have it's head coming out just hammer it in then pound along side so mud may fill hole. Screws need tight hold so little long is much better.

Answer 2

Read the directions on the bucket of drywall mud and then practice practice and remember to wear a mask when sanding its a mess. Also when you take a shower notice how the dust you are covered in and is so white turns so black when washed off .

Answer 3

I used drywallinfo.com for my project. Very good instructions. The next time, I'm going to finish with the finish mud and add a little dawn soap to the mud. (1 TBSP per 5 gallons)

Answer 4

Your local library will carry several helpful books.

If you want to own one, go to your local hardware/building store. They'll likely have pamphlets, books, DVDs and/or courses.

You can use the internet, but I find that there's usually an important step missing or major inaccuracies.

Answer 5

Many hardware stores actually have free classes for home repair, and there are also Do It Yourself videos you can buy. Just go to Home Depot or Lowes and ask. I'm sure they can help you!

Answer 6

http://www.repair-home.com/how_to/tape_and_finish_drywall.htm