how so i disarm my car alarm with out the remotes?

Question

my battery went dead so we disconnected it to replace it and now my alarm goes off. we don't have the alarm remotes.....i have a 2002 toyota tacoma

Answer 1

try to unlock drivers door with the key.if not----
is there a red light on the dash,for alarm?
-if light only,there will be a very small toggle on the panel that your left foot hits when sitting in seat.it is almost hidden.flip it with the key on then back.it should start
-if the light is actually a button, L.E.D.,with it in the out position,insert key into ign,turn to on,push the button in then out.turn off key.it should start.if the button is in,turn key in ignition to on,push button once.turn off then turn back on and push button on then off.eng.should start
if the button is in,it is in valet mode.any changes have to be done with the key on.when done the alarm should stop,fliped switch or button pushed.

Answer 2

Hook the battery up alarm will sound. Unlock the drivers door with the key. Alarm should turn off. If alarm continues try put the key into the ign and turning it to the run position.One of those usually works. Good luck hope I helped

Answer 3

Also, look to see if the car has a kill switch.
If it does, when you are starting the car, flip the switch.
This should disable to alarm.

If the car doesn't have a starter kill, you can find the brain of the alarm and just disconnect it.

All of the above is assuming you have an aftermarket alarm.

Answer 4

Go to a toyota dealer, they have the Universal Codes that will enable or disable your alarm. It is a second battery that runs those,

Answer 5

Treace the power from the fuze box.