2007-01-14 13:07:43 · 2 answers · asked by chrispgloger 1 in Cars & Transportation ➔ Car Audio
pull it out, you probally have to take the pannel off they usually just snap in, then the radio is just screwed in through the front, pull it out ,buy a wire harness at radio shack or walmart, do not cut any wires or you will be trying to figure out where the wires go for a few days.
2007-01-14 13:25:29 · answer #1 · answered by lyle2727 2 · 0⤊ 0⤋
Step 1: remove the center armrest console (2 screws on the lower rear, 2 under access panel under e-brake, and 1 or 2 inside console storage) Pull up and back to clear engaged e-brake.
Step 2: Remove 2 exposed screws by bottom of the shifter and 1 behind the ashtray. Pull off radio bezel and unplug the harnesses.
Step 3: Remove 4 screws holding in the radio and pocket. Pull out and unplug it.
Step 4: Install after market radio kit following manufacturer's instructions after wiring the new harness adaptor you should buy.
Step 6: Put it back together and enjoy.
2007-01-14 23:18:14 · answer #2 · answered by civicsound 3 · 0⤊ 0⤋