English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Two jacks for the two lines are right next to each other in one room, so if I had to connect them somehow, I think I could to it there.

We used to have two phone lines, one was for the computer, but when we got DSL we canceled the other one.

But now we have extensions in the house we'd like to use that belong to the switched-off line, and I want to try and connect them to our working phone line without having to pay the phone company to do it.

2007-01-14 06:15:42 · 5 answers · asked by Anonymous in Consumer Electronics Land Phones

5 answers

Easy 10 points here. OK, on the phone that is working if you take off the jack, you will see 4 wires there. Now if they are connected you will need to do this. Start with the red and green wire. Then disconnect the other two. See if you have a dial tone. If you do not then it is just a matter of playing musical wires till you get the dial tone then those two wires are your MAIN wires. If you do then you go to the other connection and you will see the same setup and then you connect those same colored wires up. What it is there are four wires there. Two wires are for one phone line and two are for the other phone line. Now if for some reason the 2d jack does not work still then you need to go out side to the telephone connection there.

You will see 4 wires again when you open up the plastic phone box. . Now if they are all connected no problem. I do not know if your connected wires of your extensions are seperate or not. If they were, then you have to get the wires from the other phone line and connect the two lines that work to the ones coming in from the phone company's line. So get ALL the red and yellow wires (if these were the ones connected to the working home phone) that are coming out of the house to the main phone box and connect them to the same color wire coming from the outside. Connect Red to Red and the Yellow to yellow.

Whew, or do it the other way. You can buy at a store a phone jack that plugs into the wall socket. and you just plug your phone there. It uses the electrical wire to carry the call. You plug your main phone jack in the main electrical phone plug, then anywhere in the house where you have an electrical plug you can plug in another telephone plug and get service. They run I think about $40. But call the stores and shop around. No wires and no mess.

2007-01-14 06:35:26 · answer #1 · answered by Big C 6 · 0 0

Outside your house you should have a box installed by the phone company - one side of this box will be marked customer access.
Open the customer access panel and inside you will probably have two connections that have a red and a green screw terminal on the right side.
Next to the red and green terminals is a normal house phone jack with a really short phone cable. Take a home phone that does not require an electric connection and plug it into the house style jack at the box - if you get a dial tone that is your working line. Check the other line to verify that you do not get a dial tone there.
Once you know the working line, unplug the jack from the non-working line, unscrew the red and green connections on the non-working line and move them to the working line screw connections and then reconnect the house style jack - you should have a dial tone on all the outlets in your home..

2007-01-14 08:51:56 · answer #2 · answered by Rob R 3 · 0 0

2

2016-08-12 14:38:32 · answer #3 · answered by Dorthea 3 · 0 0

Try a jumper between the two jacks (like the short one for wall mount phone) It can't hurt. (1) If you don't get dial tone on extension line in another room, then you need to check where the phone line comes in house and connect the extension line, (that is not connected), to the live junction that is. Red to Red wire on terminal screw and Green to Green wire on terminal screw. (2) if you do get a dial tone, plug a 2 way connector into the working jack. Then plug your phone into one of the jacks on connector and plug the jumper into the other jack and into the other wall jack. Got it? (2 way connector= less than $5.00) Good luck

2007-01-14 09:19:17 · answer #4 · answered by ARNEYMOUS 1 · 0 0

maximum likely, the sluggish line has better noise. it is likely not noise you could hear. if it is the case, the phone company would do not something for you. They "promise" a noise-loose line, yet it really is noise you could hear. in case you could position voice calls without noise, then they're going to evaluate there to be no problem. provided that it is dropping to twenty-eight.8, i might want to have blamed the modem. yet because you've flipped machines/modems, we may be able to rule that out. you could attempt the phone company. Ask them to come back out and attempt the noise levels on the strains. however, their attempt (in the journey that they're going to even conform to do it) will depending on the service from outdoors your position. you'll favor to pay them to attempt the interior strains. something to attempt: flow to the field outdoors your position. there'll be 2 aspects: a "shopper get precise of entry to" side (that's saved closed with an uncomplicated screw) and a "telephone company purely" side (that would have a lock or a clip on it). Open the screw side (you're allowed to attempt this). interior, you'll see 2 modular jacks, one for each of your telephone strains. they're going to be plugged into sockets. replace them. Then see what the outcomes are. obviously, in case you actually have extra telephone strains, you've to song down which line is which. you would possibly want to attempt this with information from taking an prevalent telephone (no skill mandatory) out with you and plugging it into each and each and every of the sockets. Then attempt calling each and each and every of your numbers. once you get a hectic signal, you've got here upon the line!

2016-12-02 06:25:11 · answer #5 · answered by ? 4 · 0 0

fedest.com, questions and answers