mopar electronic ignition how to wire 5 pin plug??

Question

can anyone tell me how to wire an old type mopar electronic ignition with the 5 pin plug?i bought a wiring kit,but it does not have any instructions.kit is mopar part # P3690152.

Answer 1

Here you go. Not too hard to do. I learned how to do this after my first 6cyl to 8cyl motor swap! Follow the link below!!

http://board.moparts.org/ubbthreads/showflat.php?Cat=0&Number=3129021&Main=3128802

Almost at the bottom of the page you can't miss it.

Answer 2

It is hard to draw a picture here, but I'll try. Lay your ECU down on the table with the rounded side of the plug facing right. The farthest left pin is #1 #2 is above, #4 is below. #5 is to the right.
.
#1 goes to the low side of the ignition resistor.
#2 goes to - side on coil.
#4 goes to the starter relay..
#5 goes to the pickup coil..