Having problems casting my bait-casters, help please?

Question

I've fished with spinning reels for many years and am starting to use baitcasters for certain conditions and am constantly getting backlash, I've set the reel so the lure fall's slowly when line is released, is it me or the reel? please give me a lesson on casting properly.

Answer 1

It all comes down to thumb pressure. Start with the spool set so the weight falls slowly and the spool almost stops when the weight hits the ground. Keep your thumb on the spool with light pressure as you cast and try to stop the spool as soon as the weight hits the water. You can practice in your yard with just a sinker to get the hang of it so you don't have to waste fishing time untangling backlashes. It takes a while to get the hang of it but it's well worth it to learn. As you get more comfortable with it you can back the pressure off the spool and get longer casts by using thumb pressure. I know it's frustrating but it won't take long to learn. Good luck fishing.

Answer 2

Set your drop rate as you have already learned. Hold your thumb on the spool and stop it before it gets to the end of the cast. With practice you will learn when it is the right time.
Something else to remember is the heavier the bait the easier it is to cast. Start heavy and work your way down to the lighter stuff!
Some reels are smoother than others and are easier to control.

Answer 3

Use your thumb on the spool to slow it down on casting Its frustrating but you will get better with practice some bait casters have anti backlash systems check your manual

Answer 4

Tighten the forged administration knob till it is tight. once you have your seize of determination tied on, returned this knob off till you get the seize to make a sluggish descend to the floor. you do no longer choose the seize falling so freely which you get a backlash whilst it hits the floor; purely get it to the place your seize of determination, returned, falls slowly and hits the floor devoid of the spool persevering with to spin. Then and easily then initiate tuning the magnetic braking device. The lighter the seize, the better you will probable choose the placing to be, yet once you're throwing a heavy seize, like a a million/2 ounce jig or something, you could normally turn it each and each of ways down and forged a mile, even with the greater decrease priced reel. I surely tend to maintain mine set low with approximately each and every thing i take advantage of even with the indisputable fact that; once you're a commencing up baitcaster consumer, i do no longer advise this. i take advantage of Revos, no longer Lews, yet regardless, you should be casting added than that with that reel. the two you have it poorly adjusted or you're employing some extraordinary and/or thick line. what sort of line and poundage are you employing? ---------------------- additionally, verify once you're casting which you're employing one sturdy action. the final factor you opt to do is deliver your rod returned, freeze, then forged. which will kill all your momentum and reason backlashes.

Answer 5

The easiest way to fix your problem is to take reel off the rod, walk over to your trash can, and throw it in. Go back to spinning reels!

Answer 6

You can tighten spool line a little until you get the hang of it. It takes some time to get feel of it. You probably have it too loose and are knotting it up.