2007-01-08 05:50:46 · 9 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Ford
I would not try to do it yourself, get it done at a shop. Be careful, though, make sure its done by reputable companys, it could void your warranty. Check with the dealers service dept first. Usually they cost around $300.
2007-01-08 05:55:49 · answer #1 · answered by Import Car Salesman 3 · 0⤊ 0⤋
If your car is an automatic, it is quite easy, as they have a built-in start inhibit switch already installed. Manual cars however are a different story and in fact could be potentially dangerous to install a remote start in them! Trunk release, again this is quite easy if the car has an electric trunk release, if not, then a release solenoid needs to be installed as well.
2016-05-23 11:21:21 · answer #2 · answered by ? 4 · 0⤊ 0⤋
not really, just follow instructions carefully also helps to have a good testlight. I installed one on the wifes van and on her friends van. a little advice don't leave out any of the safety devices
2007-01-11 13:57:26 · answer #3 · answered by powerstroke 1 · 0⤊ 0⤋
its difficult and if your car has the chip in the key you will have to give up a key so the remote will work. have someone do it for you .
2007-01-08 05:57:15 · answer #4 · answered by bungee 6 · 0⤊ 0⤋
I dont know as I have never tried to install one.
2007-01-08 05:57:49 · answer #5 · answered by Anonymous · 0⤊ 0⤋
Assuming it's an automatic transmission vehicle, and you have the proper tools and a well equipped shop, not very.
2007-01-08 05:56:19 · answer #6 · answered by oklatom 7 · 0⤊ 0⤋
Best let a delear install it for you
2007-01-09 10:28:42 · answer #7 · answered by fordfan7689 2 · 0⤊ 0⤋
No, you just follow the directions, they should tell you everything you need to know.
2007-01-08 05:59:17 · answer #8 · answered by mark p 2 · 0⤊ 0⤋
I don't know but I sure do want one. lol ;-)
2007-01-08 05:52:11 · answer #9 · answered by Anonymous · 0⤊ 1⤋