2007-01-07 14:04:53 · 25 answers · asked by J.R. A 1 in Cars & Transportation ➔ Car Makes ➔ Ford
Place the ignition switch in the OFF position.
Close all the vehicle doors.
Unbuckle the driver's safety belt.
Place the parklamps/headlamps switch in the OFF position. (If vehicle is equipped with Autolamps, this will not affect the procedure.)
Deactivating/Activating
Turn the ignition switch to the RUN position. (Do not start the engine.)
Wait until the safety belt warning lamp turns off (approximately one to two minutes).
NOTE: Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated.
Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This portion of the procedure can be done before or during belt minder warning activation.
Turn the parklamps/headlamps on then off.
Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the safety belt warning lamp will be illuminated for three seconds.
Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable belt minder is enabled.
The following sequence of events confirm the belt minder is enabled:
flashing of the safety belt warning belt lamp four times per second for three seconds
three seconds with the safety belt lamp off
flashing the safety belt lamp four times per second for three seconds again
The safety belt lamp flashing four times per second for three seconds provides confirmation of belt minder disabled.
After confirmation, the deactivation/activation procedure is complete.
2007-01-07 15:12:36 · answer #1 · answered by 65stang 3 · 0⤊ 1⤋
Well there is a ding for a reason...your safety...you really should wear it...what's more uncomfortable: a seatbelt or tubes running down your throat because u flew out of your windshield. This isn't something u can just 'turn off' persay...
The only way around it really is to bucked it and sit on it or get an old seat belt and stick just the buckle part in it, or something like a buckle so it thinks it's buckled.
In my state its illegal...and its click it or ticket...so watch out
2007-01-07 22:09:46 · answer #2 · answered by desirooo58 3 · 0⤊ 0⤋
Yes, do up your seatbelt like a normal sane person that not only obeys the law, but doesn't want to be thrown through the window to splatter on the pavement in an accident.. There, now wasn't that easy?
2007-01-07 22:21:41 · answer #3 · answered by Fred C 7 · 0⤊ 0⤋
The most obvious answers, of course, is to wear your seatbelt.
However, can fasten the seatbelt and then sit on top of it, or run the seatbelt around the back of the seat, if it's long enough.
2007-01-08 15:48:51 · answer #4 · answered by ramman 4 · 0⤊ 1⤋
iight dude WEAR YOUR SEATBELT!!!, if you have a deathwish you can either A, take the seatbelt buckle out of the cant and if you open it up theres a positive lead to the buckle, rip it off then reasemble. or B you can just bucke the seatbelt when your not sittin in it and never unbuckel it
2007-01-07 22:14:37 · answer #5 · answered by russ 1 · 0⤊ 1⤋
Keep your seatbelt on and obey the law and it will stop dinging.
2007-01-07 22:12:15 · answer #6 · answered by Mightymo 6 · 1⤊ 0⤋
You could wear your seatbelt, or you could just snap the seatbelt before you get in the car. Wearing it would make the most sense and be the easiest thing to do
2007-01-07 22:09:37 · answer #7 · answered by mickey 3 · 0⤊ 2⤋
I was going to say wear your freaking seat belt.. But I was beaten to it like 5 times already. Good answers everyone who said it.. ill give ya all a thumbs up
2007-01-07 22:09:16 · answer #8 · answered by Shawn S 3 · 4⤊ 0⤋
Wear the belt ... it (along with your annoying dinging reminder) is there for good reason.
2007-01-07 22:08:52 · answer #9 · answered by Anonymous · 4⤊ 0⤋
put your seat belt on the dinging stops
2007-01-07 22:41:33 · answer #10 · answered by Anonymous · 1⤊ 0⤋