Water keeps running into my toilet bowl in a thin stream. How do I repair this? Losing water nightly.?

Question

I've replaced the flap and the assembly connected to it. Thanks for your help.

Answer 1

Remove the top to the toilet system, and look for something small that turns like a dial..it'll say + or - on top it with a small arrow direction. That will adjust the water flow and stop the mini stream.

Answer 2

You have a lot of differing answers so far. There are two most likely possible causes of this, both are stated above, but I will try to summarize. First of all, there are very few causes that cannot be fixed by someone with minimal mechanical skills, so a plumber should be last resort.

1) The rubber flap: you stated that you already replaced this flap, however is the seal correct? This is the most common cause, can you press around the edges and stop the leak? is the chain getting in the way or is there something else obstructing it? Did you get a quality replacement? Even the most expensive will cost less than $10. Bleach tablets will cause these to deteriorate quickly.

2) Overflow due to water level: is water flowing over into the tall tube inside the tank? try readjusting whatever type of valve (usually float) you have to bring the water level down. This entire assembly can be replaced for ~$20 with a new float valve.

Other things to try: turn the water off behind the toilet. If the leak stops then the problem is in the supply side of things and not in the valve. If it continues even with the water off, then it is definitely something related to the flap.

Only after trying these cheap fixes would I consider getting a plumber involved. However, you can pick up a new toilet from a home improvement store for less than $100, and if you can install it yourself that would almost be the same price as the plumber visit. Toilets are fairly simple installs, you will need to buy a new grease ring ($3) and use household tools.

Good luck.

Answer 3

Water Keeps Running In Toilet

Answer 4

My Toilet Keeps Running Water

Answer 5

Most leaks like that can be repair easy. Replace the flapper that letes water run into the toilet bowl. They cost less than $5.00 and take about 5 minutes to change.

Answer 6

Take the top off the rear water closet carefully and you will see a rubber flapper valve in the middle bottom of the tank. That flapper isn't sealing fully. You can prove it by pushing down on the flapper and hearing the leak stop. You can install a new flapper you buy at a hardware store or home center.

Answer 7

it relatively is an uncomplicated restoration. Your flapper is probable undesirable and all you ought to do is get a clean one at homestead depot or some ironmongery save, drain the tank (when you turn the water off), then take out the previous flapper and placed the hot one in. The flapper is the subject that covers the hollow to hold the water interior the tank until flushed. It has a sequence on it it is hooked to the flush cope with. If it isn't the flapper then it is the ballcock. you purchase it on the comparable place and replace it the comparable way. good success

Answer 8

U REPLACED THE FLAP AND ASSEMBLY OK
IIS THE FLOAT AT THE RIGHT LEVEL TO SHUT THE WATER OFF WHEN FULL?
LIFT THE FLAP, DRY AND APPLY VASOLINE AROUND THE FLAP, IT FORM A SEAL. THIS IS ONLY TEMP TILL U CAN GET PERMANENT REPAIR

Answer 9

It's leaking through your overflow (that little pipe that sticks up. The water level when the toilet stops filling should be just below it and it will only run out it while filling. Check that tiny hose that goes into it.

Answer 10

Open the tank and make sure the lid at the bottom closes 100%. Do anything necessary for it to close like shaking the handle up & down, etc.