My PC has started turning itself back on (restarting) whenever I click on Turn off in Windows. It has only started this today, and was fine yesterday. I have checked that the power button isn't stuck and obvious things like that. Anyone got any ideas what may be causing this?
2006-12-30 02:10:47 · 7 answers · asked by clarky303 4 in Computers & Internet ➔ Hardware ➔ Desktops
Hi,
Please try this steps........
System doesn't Enter or Exit Standby Mode
If the Computer Does Not Enter or Exit Standby Mode or if the System enters standby but comes out immediately, please refer the solution provided in this link:
http://h10025.www1.hp.com/ewfrf/wc/famiDocument?dlc=&lc=en&product=12455&cc=us&docname=bph07147
And if System enters standby/Hibernation but doesn't come out, try Power Drain Steps. Because, this could be due to any charge that is left in the notebook Capacitors. To check this, let us try performing Power drain process.
To perform a Power Drain Procedure:
1.Disconnect the AC Adapter.
2.Remove the Battery.
3.Hold the Power button down for 30 seconds to 1 minute.
4.Install the battery.
5.Reconnect the AC adapter.
6.Turn on the Notebook power.
The above process will discharge the charge that is left in the Notebook Capacitors which could cause this issue.
Regards,
Prasad.
2006-12-30 02:14:33 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Right click desktop. 1) Drop down to properties.
2) Go to Screensaver.
3)Look down bottom right+click power button
4)Click Advance then adjust the setting for when you push the shut down button
2006-12-30 02:22:24 · answer #2 · answered by Anonymous · 1⤊ 0⤋
well im good with computers so if it keeps on restarting then hit the switch that runs your computer and that turns it off and soon it will be working right again or the buttons stuck if something else take your computer in or something
well good luck
2006-12-30 02:15:52 · answer #3 · answered by Kat 2 · 0⤊ 0⤋
I'm not the best person to talk to about these kind of things but this might help:on the back of your PC (where everything plugs in) there is a very small switch that most people don't notice that has a number on it, maybe if you switch it it will fix your problem. If this doesn't fix your problem be sure to switch it back.
2006-12-30 02:25:15 · answer #4 · answered by Anonymous · 0⤊ 1⤋
click on initiate, then decide on Run. interior the Run container that pops up, interior the sparkling white container variety msconfig Now a container will seem that proclaims gadget Configuration utility, the final tab says start up, decide on that one. Uncheck the products you do no longer decide directly to start, Hit prepare then ok. or you are able to visit the courses you do no longer decide directly to start, and seek by way of them, unchecking the containers that say initiate Upon homestead windows start up.
2016-10-28 17:32:36 · answer #5 · answered by ? 4 · 0⤊ 0⤋
If your computer is not working properly while you are working on it, it could be a problem with device drivers, hardware or software.
Detailed instructions at http://tinyurl.com/yk5zpr
2006-12-30 12:18:26 · answer #6 · answered by gira 3 · 0⤊ 1⤋
try checking power options in control panel
2006-12-30 02:19:41 · answer #7 · answered by Anonymous · 0⤊ 0⤋