can't figure out how to disassemble steering assembly to allow for replacement of steering coupling.
2006-12-28 12:17:32 · 4 answers · asked by ALAN N 1 in Cars & Transportation ➔ Car Makes ➔ Ford
I had to get one at Pepboys, and make it fit :(
2006-12-28 14:13:16 · answer #1 · answered by Anonymous · 0⤊ 1⤋
the coupler is secured to the steering gear on a splined shaft--one bolt secures the collar around the splined shaft when loosened --the coupler will slide off the steering gear --two bolts securing the coupler to the steering column will need to be loosened a taken out --reverse process for replacement---if the working clearance is too tight--you might need to loosen the steering column from the floor board approximately four screws secure it to the floor--- and then there are two under the dash
2006-12-28 12:48:03 · answer #2 · answered by bayliner6065 3 · 1⤊ 0⤋
pain in the butt.when looking at rag link you will see 2 things sticking up that look tike long bolt heads.they are actuall rivets and must be cut out.your replacement will come with bolts to put back.
2006-12-28 12:23:30 · answer #3 · answered by movingviolation 1 · 0⤊ 1⤋
there are a lot of places on the net that will show.. i do not remember where they are. but i have used them before. ..and they were great
2006-12-28 12:23:37 · answer #4 · answered by RED WHITE AND BLUE 4 · 0⤊ 1⤋