2 door coupe 4 cylinder
2006-12-21 06:34:48 · 7 answers · asked by WAYNE A 2 in Cars & Transportation ➔ Car Makes ➔ Nissan
i took off the top radiator hose and removed the housing which is attached to the engine block,no thermostat in there....i think it might be somewhere else...
2006-12-21 06:52:08 · update #1
If you have the 1.6 engine: The coolant inlet housing holds the thermostat, that is the upper hose on the engine side there is a housing that has a temp sensor in it and three bolts holding it to the thermostat housing. The housing goes directly to the waterpump on this model
If you have a 2.0 engine: Pretty much the same, but there is not a sensor in the three bolt housing. The housing goes to two metal hoses (from the back side of the housing) on this model.
If you removed the right part, then someone else may have removed before and not replaced it because they were too cheap to buy a new one.
2006-12-21 11:46:51 · answer #1 · answered by quick_ridez 4 · 1⤊ 0⤋
Nissan Sentra Thermostat
2017-01-16 05:19:29 · answer #2 · answered by ? 4 · 0⤊ 0⤋
This Site Might Help You.
RE:
wheres the thermostat on a 94 nissan sentra xe?
2 door coupe 4 cylinder
2015-08-06 15:25:19 · answer #3 · answered by Anonymous · 0⤊ 0⤋
You didn't mention how much coolant you need to add each time but it must be a significant amount. You should get your cooling system pressure tested. Connect a pressure tester and pump it up to the pressure rated for the car (or the rating showing on the cap). Leave it pressurized for at least 15 minutes. If the pressure drops you have a leak somewhere and need to track it down. It may be internal if there is no leak outside. If the pressure holds then it may be a problem that only happens when the engine is hot. To check this, connect the pressure tester but do not pressurize the system. Start the engine and watch the pressure buildup as the engine gets hot. If it shoots up high quickly, you may have a head gasket leak. If it gradually gets up to 15 psi and no leaks are apparent then the system is probably fine. If that is the case, connect the tester adapter to test the cap, which is probably the culprit if everything is ok. Also check the rating on the cap and make sure it matches the required pressure rating for the vehicle. Note: If you have any oil in the coolant, coolant in the oil, or white smoke in the exhaust you may have a head gasket leak. If the vehicle is automatic, check for coolant in the tranmission or auto trans fluid in the cooling system. That would indicate a leaking trans oil cooler in the radiator.
2016-03-22 19:30:57 · answer #4 · answered by ? 3 · 0⤊ 0⤋
Pop the hood.
See the radiator?
See the Big hose on top?
Follow that to the engine.
Under the thing the hose is clamped to is the thermostat.
2006-12-21 06:38:17 · answer #5 · answered by Mr. KnowItAll 7 · 0⤊ 0⤋
i own a shop,and if you,ll follow the top radiator hose down to the engine its located in the housing that bolts to the engine,,drain some of the coolant off so you wont loose it,,its a simple repair to make,,good luck hope this help,s.,,have a good x-mas.
2006-12-21 06:39:01 · answer #6 · answered by dodge man 7 · 0⤊ 0⤋
follow the top radiater hose from radiater to engine. it is in the goose neck, it is held by 2 bolts. 10 mm i think.
2006-12-21 06:39:23 · answer #7 · answered by waljac6108 5 · 0⤊ 1⤋
IN THE TRUNK
2006-12-21 06:44:19 · answer #8 · answered by Anonymous · 0⤊ 1⤋