English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

With-in the past five weeks I have had the front axle replaced and new brakes all the way around. It's an all wheel drive, V-8.

2006-12-19 14:40:15 · 9 answers · asked by ? 1 in Cars & Transportation Car Makes Ford

9 answers

Have a dealer or good shop check the transfer case for problems. Some 4WD vehicles use a viscous coupling that causes this problem at least I have seen it on a lot of Jeeps.

2006-12-19 15:36:53 · answer #1 · answered by Iknowthisone 7 · 0 0

The first guy don't know Fords, There was awd in V8's. My question is-is it in the front or rear end? You say back tires and talk about work on the front end. Where do you hear the noise
?

2006-12-19 14:52:52 · answer #2 · answered by Josh S 7 · 0 0

were you charged a diagnostic fee,did they give you a trouble code if they could not find the problem you shouldn't of been charged you can clear that light to your hearts content but this is an obd2 system and if the problem is not fixed the computer will turn on the light to indicate there is a problem and and the readiness monitors may not get ready,does the light flash while driving is it running rough hopefully you don't have a catalyst efficiency.try a different repair facility,to get a different opinion(get me a trouble code and i can give you a better answer)

2016-05-22 22:53:54 · answer #3 · answered by ? 4 · 0 0

there was only 2wd or 4wd explorers in 97 no AWD. It would be AWD if the 4wd was constant and couldn't switch between 2 and 4, however sounds like the issue is in your differential.

2006-12-19 14:46:05 · answer #4 · answered by ironh19 3 · 0 1

If the noise was when accelerating in forward or reverse with maybe a clinking sound it might be the universals, but you should check the diff fluid as well it could be low.

2006-12-19 14:48:32 · answer #5 · answered by Anonymous · 0 0

you need rear diff clutches or the 4wheel drive (awd) module reconfigured. sounds like

2006-12-19 15:50:45 · answer #6 · answered by joe b 1 · 0 1

i own a shop,and you need to jack it up ,and rotate the rear wheels with it i neutral,,and see what it sounds like then.with it not running,,the sound will change on you,,its easier to find the problem this way,,good luck hope this help,s.,,have a good x-mas.

2006-12-19 14:56:22 · answer #7 · answered by dodge man 7 · 0 2

check the bearings in the rear end or see if there mite be slack in the rear end

2006-12-19 15:03:10 · answer #8 · answered by Anonymous · 0 0

waist of money! it is the tires rubbing on the mud flaps . our '03 surburban does that too . it is perfectly fine...but annoying

2006-12-19 16:41:57 · answer #9 · answered by Anonymous · 0 2

fedest.com, questions and answers