The light is on due to a poor seal on the feul filler neck and I am not going to fix this issue.
2006-12-07 03:22:10 · 11 answers · asked by Daniel 2 in Cars & Transportation ➔ Car Makes ➔ Nissan
Disconnect the car battery for about 30 minutes. but most likely the light will come back ON again. You can also remove the light bulb. You can find the service manual in Nissanhelp.com
2006-12-08 17:16:04 · answer #1 · answered by puckparches 2 · 0⤊ 0⤋
The fix sounds simple enough, just buy a new gas cap, and wait for fifty or better key starts for it to put it's self out. Or you could just go to a local mechanic with a Snap-on scanner and have them verify the code, and turn it out for you. You can't turn the light off without a scanner, or factory scan tool. And if you leave the light on, you won't know when something else goes wrong with your vehicle.
2006-12-07 11:43:46 · answer #2 · answered by quick_ridez 4 · 0⤊ 0⤋
My corsica had the same problem but it was the sensor not the cap being lose. To reset the light unplug the battery for 5 minutes. then replug the battery and start car if the light stays off it was a loose gas cap if it comes on you'll have two choices put up with it or get the sensor fixed.
2006-12-07 03:33:13 · answer #3 · answered by brian L 6 · 0⤊ 1⤋
If you aren't going to fix the issue, pull the instrument cluster and take the bulb out. It's not going to light up any differently for future problems anyway. And I assume you could care less if it did.
But unless you plan on taking the bulb out yourself, it'd be cheaper to have the seal repaired. You're eventually going to destroy the fuel pump anyway by not fixing it, so you might as well.
Oh, black electrical tape works well to cover it up.
2006-12-07 03:35:11 · answer #4 · answered by Lemar J 6 · 1⤊ 1⤋
using a drill u can punch it out thru the frt of the dash. or u can borrow a wet suit put it on and drive ur xterra into the nearest lakje or ocean. be sure to wear the wetsuit. the light will go out then
2006-12-08 01:40:49 · answer #5 · answered by spotlite 5 · 0⤊ 0⤋
daniel go to autozone or advance auto and have them run an obd (on board diagnostic) they can clear your light only this will be a temporary fix meaning the light will come one eventually...or you can unplug the light...personally i choose awnswer a
2006-12-07 21:20:33 · answer #6 · answered by Anonymous · 0⤊ 0⤋
i own a repair shop,and if you,ll take it by any auto zone store they can erase the light off for you,but if there's a problem with it,, it will come back on again but they can tell you whats causing it to do this,and its free,,good luck,i hope this help,s,,and have a good x-mas.
2006-12-07 03:34:37 · answer #7 · answered by dodge man 7 · 1⤊ 1⤋
I have the exact same problem, and it just started as well. I am hopping some one answers this.
2016-05-23 03:39:43 · answer #8 · answered by Anonymous · 0⤊ 0⤋
Go to your Mechanic He will go into the computer and over ride the switch
2006-12-07 09:16:43 · answer #9 · answered by vipergtsrk578 3 · 0⤊ 1⤋
fix it, and it will "stop"!!!!
If your too lazy to fix it, why worry about a stupid "service engine soon" light?
2006-12-07 03:25:09 · answer #10 · answered by Anonymous · 0⤊ 2⤋