How do I drill through bathroom tiles without breaking them?

Answer 1

get some masking tape and over the place u are going to drill stick it in a cross (so the centre is on the drilling point). With a sharp masonary bit dril in one (not with hammer action). the tape prevents cracks.

Answer 2

The easiest method is to no longer put it into the tile however alternatively use a masonry bit to drill holes in the mortar across the tiles. Then use a strong masonry wall hanger to at ease the shelf to the wall utilizing your the screws that came with anchors. Hope this helps oh and in case you do must drill via the genuine tile use a masonry bit slowly and have any person shoot wd40 on the very tip every so by and large if you obtained it began

Answer 3

before drilling the tile put a bit of masking tape where u want to drill and the tile shouldn't break

Answer 4

All you need is the right drill bit. Go to the hardware store and get a tile or masonary bit, get a few cheap tiles, go home and practice. It's easy once you try it.
Sometimes they make chips or spew a little sand; wear some goggles.

Answer 5

Buy yourself a masonary bit and use that. We've drilled through tile without any problems.

Answer 6

They have a special tile drill bit, works great! any hardware store has them

Answer 7

you must absolutely use a masonry drill. It is a drill made especially for cement, tile, etc. If you use anything else, you'll break or crack it.

Answer 8

Its so easy you won't believe it ..........don't drill through your tiles, just drill through the grout; that's the filler material (cement, putty, whatever might have been used) you see in-between the tiles. Good luck, I've always done this and it always works!

Answer 9

Use a masonry drill bit