Mine did that and it was a rubber belt that goes around the drum that broke. I bought the part, it took about an hour to put it on, and it's been running for a couple of years since.
(I could hear the motor running, but it wouldn't move)
There are books that show how to fix household appliances, and it's really not too hard. Good luck.
2006-12-01 16:37:52
·
answer #1
·
answered by Rockvillerich 5
·
0⤊
1⤋
i fixed mine!
with a little wiggle the top panel of the dryer opened up
a few inches.
inside you can see the exterior of the drum.
there should be a this belt around it.
mine wasn't there!
i figured the belt had broken
inside of the dryer door there was an 1-800 number
i called it and ordered a new drive belt
it cost 15 dollars including delivery.
it was a simple repair.
i removed the dryer door
and the top. it was as easy as removing 6 small screws with a screwdriver
i fitted on the new belt threading it through the drive wheel of the motor, then around the drum
i turned the drum to make it easier to get the belt around it
i replaced the top and the door.
fixed!
the whole process took about 45 minutes
here is a picture of the belt configuration for eight major dryer manufacturers
http://groups.msn.com/Appliantology/dryers.msnw?action=ShowPhoto&PhotoID=31
the website below is helpful too!
it isn't a difficult repair and after you fix it yourself
you feel great!
http://fixitnow.com/2004/08/appliance-repair-revelation-how-does.htm
2006-12-01 21:47:08
·
answer #2
·
answered by crosscuthandsaw 2
·
0⤊
1⤋
It might have a broken belt or a defective motor. Flip down the bottom access panel and look in to see if the belt is attached or hanging loose or if the motor is not spinning.
It is an easy repair if it is the belt. It needs a pro (or a very handy amateur) if it is the motor. With new dryers running about $1000 it would pay to get it repaired.
2006-12-01 16:37:45
·
answer #3
·
answered by Rich Z 7
·
0⤊
1⤋
It may just need a new belt, which is an easy fix or it could be the drive motor which would be a more expensive fix. How old is the dryer. If it's more than 8 to 10 years old, it might just be better to buy a new one.
2006-12-01 16:37:01
·
answer #4
·
answered by ? 7
·
0⤊
1⤋
Yes, this happened to my last dryer- you would need a repair man to come in and replace the belt-- now, I dont know where you live, but you may want to call repair shops and see what they would cost to replace the belt-- tell them the name and make and model no of your dryer- and depending on the price of repair- they do have to come to your home to do it, and how hold your dryer is, you may want to look into a new dryer--I am in exactly the same situation- my dryer is soooo loud right now I know it will die one day before Christmas!!!
2006-12-01 16:37:07
·
answer #5
·
answered by mac 6
·
0⤊
2⤋
can you hear a motor running? if so you probably have a broken belt. what brand is it? there may be two motors, one for air and one to rotate the drum. do not leave it on heat without the fan running or the drum rotating. some drums are driven directly by the motor which may or may not be bad. it may just have a loose connection. if it is very old it may be cheaper to buy a new one considering what servicemen charge now. the dealer you got it from would be your best bet to have it checked if you cannot do it yourself.
2006-12-01 16:45:21
·
answer #6
·
answered by clydephelpssr 2
·
0⤊
1⤋
Your dryer uses a fan belt, it has probably broken. It is a cheap part. Call a repairman, give him the model number and serial number of your make and model of dryer. He can replace it for you.
2006-12-01 16:45:11
·
answer #7
·
answered by teacupn 6
·
0⤊
1⤋
yes. sounds like it's the drive belt that causes the rotation....simple repair.
2006-12-01 16:34:47
·
answer #8
·
answered by Tragedy 3
·
0⤊
0⤋
Yeah, it sounds like it's probably just the belt. If it's not the belt, then it could be the motor, & you'd have to get a new motor but it does sound repairable.
2006-12-01 16:36:07
·
answer #9
·
answered by angeeland 2
·
0⤊
2⤋
You may have a broken drum drive belt. Yes ---this is easy to repair.
2006-12-01 16:42:10
·
answer #10
·
answered by Spock 5
·
0⤊
1⤋