drum 200 lit of capacity filled upto 170 liters
to heat hydraulic oil mix with water, what is the capacity of heater to reach temp 90 degre within 30 minute.
water content in in hydraulic oil may be 2 to 20 litre
purpuse is to remove water from hydraulic oil.
2006-11-29 00:51:23 · 2 answers · asked by shaikh g 1 in Science & Mathematics ➔ Engineering
Archive News Story
(Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Filtration System removes contaminants in hydraulic oil.
June 11, 2003 - Portable Hydraulic Oil Filtration System connects to injection molding machine oil reservoir through 2 lines and can be equipped with quick connect/disconnect fittings. Flow rates range from 3–24 gpm and filter through 3 filtration stages. Using cycle of passes through system, 98% of all contaminants are removed, extending hydraulic oil life 8–10 times or more.
Send emailContact company
Company Profile at ThomasNet.com
company web siteCompany web site
more company newsMore news from this company
web search for more informationSearch the industrial web for: "hydraulic oil heating in drum"
directory searchSearch for suppliers of:
Filtration Systems: Industrial Oil
Advertisement
Archive Press Release
(Products mentioned in this Archive Press Release may or may not be available from the manufacturer.)
Release date: June 6, 2003
The Leading Preventable Cause of Injection Molding Machine Breakdown is Hydraulic System Malfunction
Without proper maintenance, your hydraulic systems components life span may be reduced by up to 75%. This leads not only to costly equipment repair, but to expensive down time as well. Combine that with new, stricter environmental regulations concerning the disposal of waste oil, and you have a potential operating capital drain. With the application being Hydraulic oil, the primary degrader of oil, HEAT, is not a factor. Water and dirt particles are the enemies of the hydraulic oil.
Our engineered process removes these contaminants¹ quickly and efficiently. Our portable systems will connect to the injection molding machine oil reservoir through two 1² lines. The units can be equipped with quick connect/disconnect fittings. The flow rates range from 3 24 GPM and filter through three filtration stages. Using a cycle of passes through the system, 98 percent of all contaminants are removed from the hydraulic oil. This simple service can extend your hydraulic oil life 8 10 times or more.
The Glanon Hydraulic Oil Filtration System is shipped from the factory equipped and ready for immediate service. Portable and easily maneuverable, this system can service multiple Injection Molding Machines in a single day.
An Injection Molding Machine can easily be serviced without manually draining and refilling the oil. Hydraulic system maintenance hours will be reduced, oil life will be increased, and environmental impact will be minimized.
2006-11-29 01:10:57 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Heat the oil for 100 deg celcius and maintain it for few hours
2006-11-29 03:39:42 · answer #2 · answered by afk 3 · 0⤊ 0⤋