When i pull the lever back on my high beam switch on the steering column it cuts on but have to hold it, now if I push it like its suppose to for the high beams all lights go off and in the middle just low beams on which is right. whats wrong need help ASAP inspection runs out this month thanks
2006-11-06 14:29:40 · 5 answers · asked by leahssweetie 1 in Cars & Transportation ➔ Car Makes ➔ Ford
when i pull it the high beams come on but have to hold it if i push it all lights go out
2006-11-06 15:31:53 · update #1
sounds like a relay, when you pull thats the highbeam flash :)
2006-11-06 14:35:21 · answer #1 · answered by Anonymous · 0⤊ 1⤋
Check all grounds first, then chech the switch itself, it can do this as well as the high beam relay
2006-11-06 23:59:18 · answer #2 · answered by Josh S 7 · 0⤊ 0⤋
i own a repair shop,and i have seen them do this before,it may have a bad switch on it this is how they do when they go bad ,sometimes they knock all the light,s out when they go out ,,there is a relay for them also but it usually don't act like this when it goes bad you just loose the lights all together on it,but you may have to take it in to a repair shop,and have them do a check on it to make sure,electrical problems can be tricky sometimes and real hard to find also,good luck with it,i hope this help,s.
2006-11-06 22:42:34 · answer #3 · answered by dodge man 7 · 0⤊ 1⤋
sounds like the dimmer switch
2006-11-06 22:36:54 · answer #4 · answered by 007 4 · 1⤊ 0⤋
Your switch is bad.
2006-11-09 20:02:06 · answer #5 · answered by George K 6 · 0⤊ 0⤋