English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

1 answers

pull the tops of all the door seals loose remove sunvisors dome light eye glass case windshield pillar trim b post seat belt anchors and trim pop loose the c post rear window side trims l=just let them hang, Now remove the glass panel set some where safe remove the head rests slide front seats foward and recline them all the way back the head liner has a ring around the opening be very careful not to smash it or bend much you have to get this back clipped to the sunroof frame and head liner at the same time very clean hands are needed wash a lot after handling the track motor you will be greasy. I let the head liner sit on the seats and work above removing the four drain tubes and the 10 mm bolts, the frame turns out the passengers side front door. This is not hard or heavy work expect to make a day of it the first time in. Do you have #20 torx driver go out and get one ( for the glass panel screws ) adjust the glass panel up and down to be slightly higher than the roof. Below flush will make wind noise

2006-11-05 01:04:09 · answer #1 · answered by John Paul 7 · 0 0

fedest.com, questions and answers